Big Green Egg
Temperature Gauge, 3 inch Dial in Wrightstown, WI
MSRP
Product Information
This high quality, stainless steel temperature gauge - with a large, easy-to-read 3 inch dial - precisely monitors the temperatures inside the dome of an EGG, allowing you to achieve and maintain precise cooking temperatures Oversized 3 in (8 cm) Dial Stainless Steel External Temperature Gauge - 117250
- 750F deg / 400C deg
- Works with XXLarge, XLarge, Large, Medium, Small and MiniMax EGGs
- Heavy duty construction, hermetically sealed
- Designed and manufactured in the USA
Installation:
- Carefully insert stem from the outside through small hole in dome of the EGG; the silicone washer should remain on the outside of the EGG.
- Carefully reach inside the dome, and slide retaining clip onto the stem. Squeeze the clip so that it slides easily.
- Slide clip up the stem until the silicone washer -x001F-ts snugly against the exterior of the dome. For accurate reading, thermometer must be installed past the groove on the lower portion of stem as shown below.
This thermometer is calibrated and adjusted at the factory. If you are in high altitudes or wish to check the calibration:
- Bring a clean container of water to a boil.
- Carefully place the end of the thermometer probe into boiling water past the groove on the lower portion of stem. Leave immersed for at least one minute taking care not to let the probe rest on or make contact with the container.
- Boiling point will read 212 deg F/100 deg C at sea level. Boiling point decreases approx 2 deg with each 1000' of altitude. If the thermometer does not read 212 deg F/100 deg C at sea level, calibration can be reset by carefully holding the thermometer head and turning the hex nut with a wrench to move dial in one direction or the other.
- CAUTION - Do not adjust hot thermometer with bare hands!
- CAUTION - Do not hold thermometer with bare hands while placing in boiling water as burns can result!
- CAUTION - Thermometer tip is sharp, do not leave unattended or place within reach of children.
Select a Store
Selected Store
18 locations / In stock at 18
In stock at 17 other locations
Ace Hardware of Appleton
500 E Northland Ave
Appleton, WI 54911
Kitz & Pfeil Hardware Appleton
1919 E. Calumet
Appleton, WI 54915
Kimps Ace Hardware of Ashwaubenon
2110 S Ridge Rd
Green Bay, WI 54304
Scheels -Appleton
4301 W Wisconsin Ave
Appleton, WI 54913
Kimps Ace Hardware
2548 Glendale Ave
Green Bay, WI 54313
Kitz & Pfeil Oshkosh
427 N Main St
Oshkosh, WI 54901
Door County Ace Hardware
(1 Review)
1225 Egg Harbor Rd
Sturgeon Bay, WI 54235
Martens Ace Hardware
(1 Review)
1100 W Main Street
Waupun, WI 53963
Andy's Ace Hardware
1307 8th Ave
Menominee, MI 49858
Ozaukee Ace Hardware
1818 Wisconsin Ave
Grafton, WI 53024
Hahn Ace Hardware
2945 State Road 83
Hartford, WI 53027
Hahn Ace Hardware
11001 N Port Washington Rd
Mequon, WI 53092
Village Ace Hardware
6240 N Port Washington Rd
Glendale, WI 53217
Niemann Ace Hardware - Portage
2830 New Pinery Rd
Portage, WI 53901
Kimps Ace Hardware
540 County Road U
Wrightstown, WI 54180
Ace Hardware Luxemburg
606 Center Dr
Luxemburg, WI 54217
Brazee Ace Hardware of Winneconne
926 E Main Street
Winneconne, WI 54986
Nelson Shopping Center Ace Hardware
3449 WI-42
Fish Creek, WI 54212
Directions
Contact
Website
Product Information
This high quality, stainless steel temperature gauge - with a large, easy-to-read 3 inch dial - precisely monitors the temperatures inside the dome of an EGG, allowing you to achieve and maintain precise cooking temperatures Oversized 3 in (8 cm) Dial Stainless Steel External Temperature Gauge - 117250
- 750F deg / 400C deg
- Works with XXLarge, XLarge, Large, Medium, Small and MiniMax EGGs
- Heavy duty construction, hermetically sealed
- Designed and manufactured in the USA
Installation:
- Carefully insert stem from the outside through small hole in dome of the EGG; the silicone washer should remain on the outside of the EGG.
- Carefully reach inside the dome, and slide retaining clip onto the stem. Squeeze the clip so that it slides easily.
- Slide clip up the stem until the silicone washer -x001F-ts snugly against the exterior of the dome. For accurate reading, thermometer must be installed past the groove on the lower portion of stem as shown below.
This thermometer is calibrated and adjusted at the factory. If you are in high altitudes or wish to check the calibration:
- Bring a clean container of water to a boil.
- Carefully place the end of the thermometer probe into boiling water past the groove on the lower portion of stem. Leave immersed for at least one minute taking care not to let the probe rest on or make contact with the container.
- Boiling point will read 212 deg F/100 deg C at sea level. Boiling point decreases approx 2 deg with each 1000' of altitude. If the thermometer does not read 212 deg F/100 deg C at sea level, calibration can be reset by carefully holding the thermometer head and turning the hex nut with a wrench to move dial in one direction or the other.
- CAUTION - Do not adjust hot thermometer with bare hands!
- CAUTION - Do not hold thermometer with bare hands while placing in boiling water as burns can result!
- CAUTION - Thermometer tip is sharp, do not leave unattended or place within reach of children.
Product Reviews
There are no reviews yet for Big Green Egg: Temperature Gauge, 3 inch Dial .
Write a Review
