Big Green Egg
Temperature Gauge, 3 inch Dial in Sumter, SC
MSRP
Product Information
This high quality, stainless steel temperature gauge - with a large, easy-to-read 3 inch dial - precisely monitors the temperatures inside the dome of an EGG, allowing you to achieve and maintain precise cooking temperatures Oversized 3 in (8 cm) Dial Stainless Steel External Temperature Gauge - 117250
- 750F deg / 400C deg
- Works with XXLarge, XLarge, Large, Medium, Small and MiniMax EGGs
- Heavy duty construction, hermetically sealed
- Designed and manufactured in the USA
Installation:
- Carefully insert stem from the outside through small hole in dome of the EGG; the silicone washer should remain on the outside of the EGG.
- Carefully reach inside the dome, and slide retaining clip onto the stem. Squeeze the clip so that it slides easily.
- Slide clip up the stem until the silicone washer -x001F-ts snugly against the exterior of the dome. For accurate reading, thermometer must be installed past the groove on the lower portion of stem as shown below.
This thermometer is calibrated and adjusted at the factory. If you are in high altitudes or wish to check the calibration:
- Bring a clean container of water to a boil.
- Carefully place the end of the thermometer probe into boiling water past the groove on the lower portion of stem. Leave immersed for at least one minute taking care not to let the probe rest on or make contact with the container.
- Boiling point will read 212 deg F/100 deg C at sea level. Boiling point decreases approx 2 deg with each 1000' of altitude. If the thermometer does not read 212 deg F/100 deg C at sea level, calibration can be reset by carefully holding the thermometer head and turning the hex nut with a wrench to move dial in one direction or the other.
- CAUTION - Do not adjust hot thermometer with bare hands!
- CAUTION - Do not hold thermometer with bare hands while placing in boiling water as burns can result!
- CAUTION - Thermometer tip is sharp, do not leave unattended or place within reach of children.
Select a Store
Selected Store
19 locations / In stock at 19
In stock at 18 other locations
Simpson Ace Hardware
40 W Wesmark Blvd
Sumter, SC 29150
Wateree Ace Hardware
886 Hwy 1 South
Lugoff, SC 29078
Elder's Ace Hardware-Florence
155 S Cashua Drive
Florence, SC 29501
Jack Oliver's Pool Service
3303 Forest Drive
Columbia, SC 29204
South East Ace, Inc.
815 State St
Cayce, SC 29033
Holly Hill Ace
8516 Old States Rd
Holly Hill, SC 29059
Three Fountains Ace Hardware
2930 Emanuel Church Rd
West Columbia, SC 29170
Bob's Ace Hardware
345 E Columbia Ave
Leesville, SC 29070
Duncan Ace Hardware - Goose Creek
925 Red Bank Rd
Goose Creek, SC 29445
Westbury Ace Hardware
1050 Bells Hwy
Walterboro, SC 29488
Waxhaw Ace Hardware
3927 Providence Rd South
Waxhaw, NC 28173
Heuser Ace - Pawleys Island
8317 Ocean Highway
Pawleys Island, SC 29585
Rock Hill Ace Hardware
725 Cherry Rd
Rock Hill, SC 29732
Simpson Hardware & Sports
222 North Church St
Lake City, SC 29560
Socastee Ace Hardware Store
4860 Dick Pond Rd
Myrtle Beach, SC 29588
The Coastal Cupboard
644-J Long Point Rd
Mt. Pleasant, SC 29464
Westlake Ace of Charlotte
15221 John J Delaney Dr
Charlotte, NC 28277
Aiken Ace Hardware
1650 Richland Ave W
Aiken, SC 29801
New Ellenton Ace Hardware
605 Main Street
New Ellenton, SC 29809
Product Information
This high quality, stainless steel temperature gauge - with a large, easy-to-read 3 inch dial - precisely monitors the temperatures inside the dome of an EGG, allowing you to achieve and maintain precise cooking temperatures Oversized 3 in (8 cm) Dial Stainless Steel External Temperature Gauge - 117250
- 750F deg / 400C deg
- Works with XXLarge, XLarge, Large, Medium, Small and MiniMax EGGs
- Heavy duty construction, hermetically sealed
- Designed and manufactured in the USA
Installation:
- Carefully insert stem from the outside through small hole in dome of the EGG; the silicone washer should remain on the outside of the EGG.
- Carefully reach inside the dome, and slide retaining clip onto the stem. Squeeze the clip so that it slides easily.
- Slide clip up the stem until the silicone washer -x001F-ts snugly against the exterior of the dome. For accurate reading, thermometer must be installed past the groove on the lower portion of stem as shown below.
This thermometer is calibrated and adjusted at the factory. If you are in high altitudes or wish to check the calibration:
- Bring a clean container of water to a boil.
- Carefully place the end of the thermometer probe into boiling water past the groove on the lower portion of stem. Leave immersed for at least one minute taking care not to let the probe rest on or make contact with the container.
- Boiling point will read 212 deg F/100 deg C at sea level. Boiling point decreases approx 2 deg with each 1000' of altitude. If the thermometer does not read 212 deg F/100 deg C at sea level, calibration can be reset by carefully holding the thermometer head and turning the hex nut with a wrench to move dial in one direction or the other.
- CAUTION - Do not adjust hot thermometer with bare hands!
- CAUTION - Do not hold thermometer with bare hands while placing in boiling water as burns can result!
- CAUTION - Thermometer tip is sharp, do not leave unattended or place within reach of children.
Product Reviews
There are no reviews yet for Big Green Egg: Temperature Gauge, 3 inch Dial .
Write a Review