Big Green Egg
Temperature Gauge, 3 inch Dial in Springfield, TN 37172
MSRP
Product Information
This high quality, stainless steel temperature gauge - with a large, easy-to-read 3 inch dial - precisely monitors the temperatures inside the dome of an EGG, allowing you to achieve and maintain precise cooking temperatures Oversized 3 in (8 cm) Dial Stainless Steel External Temperature Gauge - 117250
- 750F deg / 400C deg
- Works with XXLarge, XLarge, Large, Medium, Small and MiniMax EGGs
- Heavy duty construction, hermetically sealed
- Designed and manufactured in the USA
Installation:
- Carefully insert stem from the outside through small hole in dome of the EGG; the silicone washer should remain on the outside of the EGG.
- Carefully reach inside the dome, and slide retaining clip onto the stem. Squeeze the clip so that it slides easily.
- Slide clip up the stem until the silicone washer -x001F-ts snugly against the exterior of the dome. For accurate reading, thermometer must be installed past the groove on the lower portion of stem as shown below.
This thermometer is calibrated and adjusted at the factory. If you are in high altitudes or wish to check the calibration:
- Bring a clean container of water to a boil.
- Carefully place the end of the thermometer probe into boiling water past the groove on the lower portion of stem. Leave immersed for at least one minute taking care not to let the probe rest on or make contact with the container.
- Boiling point will read 212 deg F/100 deg C at sea level. Boiling point decreases approx 2 deg with each 1000' of altitude. If the thermometer does not read 212 deg F/100 deg C at sea level, calibration can be reset by carefully holding the thermometer head and turning the hex nut with a wrench to move dial in one direction or the other.
- CAUTION - Do not adjust hot thermometer with bare hands!
- CAUTION - Do not hold thermometer with bare hands while placing in boiling water as burns can result!
- CAUTION - Thermometer tip is sharp, do not leave unattended or place within reach of children.
Select a Store
Selected Store
22 locations / In stock at 22
In stock at 21 other locations
Ace Hardware Springfield
400 Central Ave E
Springfield, TN 37172
Ace Hardware White House
429 TN-76
White House, TN 37188
Hendersonville Ace Hardware
500 West Main Street Ste 260
Hendersonville, TN 37075
Portland Ace Hardware
511 S Broadway
Portland, TN 37148
Ace Hardware Marketplace Franklin
710 El Cedar Street
Franklin, KY 42134
Elder's Ace Hardware of East Nashville
2622 Gallatin Pike
Nashville, TN 37216
Tennessee Hardware
441 E. Broadway
Gallatin, TN 37066
Ace Hardware
1435 New Gallatin Road
Scottsville, KY 42164
Northgate Ace Marketplace
3170 Louisville Rd
Bowling Green, KY 42101
Tripp's Ace Hardware
112 E James Campbell Blvd
Columbia, TN 38401
Cave City Ace Hardware
9586 Happy Valley Rd
Cave City, KY 42127
Akridge Farm Supply
724 W Fairview Avenue
Eddyville, KY 42038
Potters Ace Hardware
325 Newman Dr
Cookeville, TN 38501
Potters Ace Hardware
615 W Main Street
Algood, TN 38506
615 Outdoor Living
9857 Lebanon Rd
Mt. Juliet, TN 37122
B & C Hardware
124 Pewitt Dr
Brentwood, TN 37027
Elder's Ace Hardware of Smyrna
(1 Review)
415 Nissan Dr
Smyrna, TN 37167
Butters Ace Hardware
1109 Elliston Way
Thompson's Station, TN 37179
Lafayette Ace Hardware
411 Highway 52 Bypass East
Lafayette, TN 37083
Elder's Ace Hardware of Murfreesboro
1807 Memorial Blvd
Murfreesboro, TN 37129
Hartford Ace Hardware
1102 Main Street
Hartford, KY 42347
Metcalfe Landscaping
410 Princeton Road
Madisonville, KY 42431
Directions
Contact
Website
Product Information
This high quality, stainless steel temperature gauge - with a large, easy-to-read 3 inch dial - precisely monitors the temperatures inside the dome of an EGG, allowing you to achieve and maintain precise cooking temperatures Oversized 3 in (8 cm) Dial Stainless Steel External Temperature Gauge - 117250
- 750F deg / 400C deg
- Works with XXLarge, XLarge, Large, Medium, Small and MiniMax EGGs
- Heavy duty construction, hermetically sealed
- Designed and manufactured in the USA
Installation:
- Carefully insert stem from the outside through small hole in dome of the EGG; the silicone washer should remain on the outside of the EGG.
- Carefully reach inside the dome, and slide retaining clip onto the stem. Squeeze the clip so that it slides easily.
- Slide clip up the stem until the silicone washer -x001F-ts snugly against the exterior of the dome. For accurate reading, thermometer must be installed past the groove on the lower portion of stem as shown below.
This thermometer is calibrated and adjusted at the factory. If you are in high altitudes or wish to check the calibration:
- Bring a clean container of water to a boil.
- Carefully place the end of the thermometer probe into boiling water past the groove on the lower portion of stem. Leave immersed for at least one minute taking care not to let the probe rest on or make contact with the container.
- Boiling point will read 212 deg F/100 deg C at sea level. Boiling point decreases approx 2 deg with each 1000' of altitude. If the thermometer does not read 212 deg F/100 deg C at sea level, calibration can be reset by carefully holding the thermometer head and turning the hex nut with a wrench to move dial in one direction or the other.
- CAUTION - Do not adjust hot thermometer with bare hands!
- CAUTION - Do not hold thermometer with bare hands while placing in boiling water as burns can result!
- CAUTION - Thermometer tip is sharp, do not leave unattended or place within reach of children.
Product Reviews
There are no reviews yet for Big Green Egg: Temperature Gauge, 3 inch Dial .
Write a Review
