Big Green Egg
Temperature Gauge, 3 inch Dial in Rincon, GA 31326
MSRP
Product Information
This high quality, stainless steel temperature gauge - with a large, easy-to-read 3 inch dial - precisely monitors the temperatures inside the dome of an EGG, allowing you to achieve and maintain precise cooking temperatures Oversized 3 in (8 cm) Dial Stainless Steel External Temperature Gauge - 117250
- 750F deg / 400C deg
- Works with XXLarge, XLarge, Large, Medium, Small and MiniMax EGGs
- Heavy duty construction, hermetically sealed
- Designed and manufactured in the USA
Installation:
- Carefully insert stem from the outside through small hole in dome of the EGG; the silicone washer should remain on the outside of the EGG.
- Carefully reach inside the dome, and slide retaining clip onto the stem. Squeeze the clip so that it slides easily.
- Slide clip up the stem until the silicone washer -x001F-ts snugly against the exterior of the dome. For accurate reading, thermometer must be installed past the groove on the lower portion of stem as shown below.
This thermometer is calibrated and adjusted at the factory. If you are in high altitudes or wish to check the calibration:
- Bring a clean container of water to a boil.
- Carefully place the end of the thermometer probe into boiling water past the groove on the lower portion of stem. Leave immersed for at least one minute taking care not to let the probe rest on or make contact with the container.
- Boiling point will read 212 deg F/100 deg C at sea level. Boiling point decreases approx 2 deg with each 1000' of altitude. If the thermometer does not read 212 deg F/100 deg C at sea level, calibration can be reset by carefully holding the thermometer head and turning the hex nut with a wrench to move dial in one direction or the other.
- CAUTION - Do not adjust hot thermometer with bare hands!
- CAUTION - Do not hold thermometer with bare hands while placing in boiling water as burns can result!
- CAUTION - Thermometer tip is sharp, do not leave unattended or place within reach of children.
Select a Store
Selected Store
19 locations / In stock at 19
In stock at 18 other locations
Heuser Ace Hardware - New River
(1 Review)
259 Copper Plate Rd
Hardeeville, SC 29927
Berwick Ace Hardware
(1 Review)
5698 Ogeechee Rd
Savannah, GA 31405
Heuser Ace Hardware
29 Innovation Dr
Bluffton, SC 29910
Islands Ace Hardware
318 Johnny Mercer Blvd Ste 5
Savannah, GA 31410
Ace Hardware of Hilton Head
3 Northridge Dr
Hilton Head Island, SC 29926
Port Royal Ace
(2 Reviews)
1347 Ribaut Rd
Port Royal, SC 29935
Ace Hardware of Statesboro
(1 Review)
1870 Northside Dr E
Statesboro, GA 30458
Claxton Ace Hardware
501 E Main Street
Claxton, GA 30417
Westbury Ace Hardware
1050 Bells Hwy
Walterboro, SC 29488
Johns Island Ace
3714 Betsy Kerrison Pkwy
Johns Island, SC 29455
Hunter Johnson Ace Hardware
870 East Parker Street
Baxley, GA 31513
Harris Ace Hardware
2185 Perry Lane Road
Brunswick, GA 31525
Island Ace Hardware
329 Longview Plaza
St. Simons Island, GA 31522
Duncan Ace Hardware - Goose Creek
925 Red Bank Rd
Goose Creek, SC 29445
Rincon Ace Hardware
591 S Columbia Ave
Rincon, GA 31326
Salter Building Supply
287 Old Millen Hwy
Waynesboro, GA 30830
Lowcountry Ace Hardware
1411 Folly Rd
Charleston, SC 29412
New Ellenton Ace Hardware
605 Main Street
New Ellenton, SC 29809
Summit Ace of Louisville
815 Peachtree St
Louisville, GA 30434
Directions
Contact
Website
Product Information
This high quality, stainless steel temperature gauge - with a large, easy-to-read 3 inch dial - precisely monitors the temperatures inside the dome of an EGG, allowing you to achieve and maintain precise cooking temperatures Oversized 3 in (8 cm) Dial Stainless Steel External Temperature Gauge - 117250
- 750F deg / 400C deg
- Works with XXLarge, XLarge, Large, Medium, Small and MiniMax EGGs
- Heavy duty construction, hermetically sealed
- Designed and manufactured in the USA
Installation:
- Carefully insert stem from the outside through small hole in dome of the EGG; the silicone washer should remain on the outside of the EGG.
- Carefully reach inside the dome, and slide retaining clip onto the stem. Squeeze the clip so that it slides easily.
- Slide clip up the stem until the silicone washer -x001F-ts snugly against the exterior of the dome. For accurate reading, thermometer must be installed past the groove on the lower portion of stem as shown below.
This thermometer is calibrated and adjusted at the factory. If you are in high altitudes or wish to check the calibration:
- Bring a clean container of water to a boil.
- Carefully place the end of the thermometer probe into boiling water past the groove on the lower portion of stem. Leave immersed for at least one minute taking care not to let the probe rest on or make contact with the container.
- Boiling point will read 212 deg F/100 deg C at sea level. Boiling point decreases approx 2 deg with each 1000' of altitude. If the thermometer does not read 212 deg F/100 deg C at sea level, calibration can be reset by carefully holding the thermometer head and turning the hex nut with a wrench to move dial in one direction or the other.
- CAUTION - Do not adjust hot thermometer with bare hands!
- CAUTION - Do not hold thermometer with bare hands while placing in boiling water as burns can result!
- CAUTION - Thermometer tip is sharp, do not leave unattended or place within reach of children.
Product Reviews
There are no reviews yet for Big Green Egg: Temperature Gauge, 3 inch Dial .
Write a Review
