Big Green Egg
Temperature Gauge, 3 inch Dial in Ramona, CA 92065
MSRP
Product Information
This high quality, stainless steel temperature gauge - with a large, easy-to-read 3 inch dial - precisely monitors the temperatures inside the dome of an EGG, allowing you to achieve and maintain precise cooking temperatures Oversized 3 in (8 cm) Dial Stainless Steel External Temperature Gauge - 117250
- 750F deg / 400C deg
- Works with XXLarge, XLarge, Large, Medium, Small and MiniMax EGGs
- Heavy duty construction, hermetically sealed
- Designed and manufactured in the USA
Installation:
- Carefully insert stem from the outside through small hole in dome of the EGG; the silicone washer should remain on the outside of the EGG.
- Carefully reach inside the dome, and slide retaining clip onto the stem. Squeeze the clip so that it slides easily.
- Slide clip up the stem until the silicone washer -x001F-ts snugly against the exterior of the dome. For accurate reading, thermometer must be installed past the groove on the lower portion of stem as shown below.
This thermometer is calibrated and adjusted at the factory. If you are in high altitudes or wish to check the calibration:
- Bring a clean container of water to a boil.
- Carefully place the end of the thermometer probe into boiling water past the groove on the lower portion of stem. Leave immersed for at least one minute taking care not to let the probe rest on or make contact with the container.
- Boiling point will read 212 deg F/100 deg C at sea level. Boiling point decreases approx 2 deg with each 1000' of altitude. If the thermometer does not read 212 deg F/100 deg C at sea level, calibration can be reset by carefully holding the thermometer head and turning the hex nut with a wrench to move dial in one direction or the other.
- CAUTION - Do not adjust hot thermometer with bare hands!
- CAUTION - Do not hold thermometer with bare hands while placing in boiling water as burns can result!
- CAUTION - Thermometer tip is sharp, do not leave unattended or place within reach of children.
Select a Store
Selected Store
17 locations / In stock at 17
In stock at 16 other locations
Ransom Brothers Ace
1441 Main Street
Ramona, CA 92065
Griffin Ace Hardware
10511 4S Commons Dr
San Diego, CA 92127
Alpine Ace Hardware
1347 Tavern Rd
Alpine, CA 91901
Griffin Ace Hardware
3880 Valley Center Dr
San Diego, CA 92130
Crown Ace hardware
4615 Clairemont Dr
San Diego, CA 92117
Fallbrook Ace Hardware
640 S Main Ave
Fallbrook, CA 92028
Palm Desert Ace Hardware
74058 Hwy 111
Palm Desert, CA 92260
Palm Springs Ace Hardware
1785 E Palm Canyon Dr
Palm Springs, CA 92264
Crown Ace Hardware
3107 E Coast Highway
Corona del Mar, CA 92625
Crown Ace Hardware
(2 Reviews)
9045 Adams Ave
Huntington Beach, CA 92646
Brawley Ace Hardware
415 W Main Street
Brawley, CA 92227
El Centro Ace
1041 N Imperial Ave
El Centro, CA 92243
Fullerton Ace Hardware
117 W. Commonwealth Ave
Fullerton, CA 92832
San Carlos Ace Hardware
7375 Jackson St
San Diego, CA 92119
West Coast BBQ Shop
2330 Proctor Valley Rd
Chula Vista, CA 91914
Westlake Ace Hardware
31541 Santa Margarita Pkwy
Rancho Santa Margarita, CA 92688
Westlake Ace Hardware
(1 Review)
1257 E Yorba Linda Blvd
Placentia, CA 92870
Directions
Contact
Website
Product Information
This high quality, stainless steel temperature gauge - with a large, easy-to-read 3 inch dial - precisely monitors the temperatures inside the dome of an EGG, allowing you to achieve and maintain precise cooking temperatures Oversized 3 in (8 cm) Dial Stainless Steel External Temperature Gauge - 117250
- 750F deg / 400C deg
- Works with XXLarge, XLarge, Large, Medium, Small and MiniMax EGGs
- Heavy duty construction, hermetically sealed
- Designed and manufactured in the USA
Installation:
- Carefully insert stem from the outside through small hole in dome of the EGG; the silicone washer should remain on the outside of the EGG.
- Carefully reach inside the dome, and slide retaining clip onto the stem. Squeeze the clip so that it slides easily.
- Slide clip up the stem until the silicone washer -x001F-ts snugly against the exterior of the dome. For accurate reading, thermometer must be installed past the groove on the lower portion of stem as shown below.
This thermometer is calibrated and adjusted at the factory. If you are in high altitudes or wish to check the calibration:
- Bring a clean container of water to a boil.
- Carefully place the end of the thermometer probe into boiling water past the groove on the lower portion of stem. Leave immersed for at least one minute taking care not to let the probe rest on or make contact with the container.
- Boiling point will read 212 deg F/100 deg C at sea level. Boiling point decreases approx 2 deg with each 1000' of altitude. If the thermometer does not read 212 deg F/100 deg C at sea level, calibration can be reset by carefully holding the thermometer head and turning the hex nut with a wrench to move dial in one direction or the other.
- CAUTION - Do not adjust hot thermometer with bare hands!
- CAUTION - Do not hold thermometer with bare hands while placing in boiling water as burns can result!
- CAUTION - Thermometer tip is sharp, do not leave unattended or place within reach of children.
Product Reviews
There are no reviews yet for Big Green Egg: Temperature Gauge, 3 inch Dial .
Write a Review
