Big Green Egg
Temperature Gauge, 3 inch Dial in Orange Beach, AL
MSRP
Product Information
This high quality, stainless steel temperature gauge - with a large, easy-to-read 3 inch dial - precisely monitors the temperatures inside the dome of an EGG, allowing you to achieve and maintain precise cooking temperatures Oversized 3 in (8 cm) Dial Stainless Steel External Temperature Gauge - 117250
- 750F deg / 400C deg
- Works with XXLarge, XLarge, Large, Medium, Small and MiniMax EGGs
- Heavy duty construction, hermetically sealed
- Designed and manufactured in the USA
Installation:
- Carefully insert stem from the outside through small hole in dome of the EGG; the silicone washer should remain on the outside of the EGG.
- Carefully reach inside the dome, and slide retaining clip onto the stem. Squeeze the clip so that it slides easily.
- Slide clip up the stem until the silicone washer -x001F-ts snugly against the exterior of the dome. For accurate reading, thermometer must be installed past the groove on the lower portion of stem as shown below.
This thermometer is calibrated and adjusted at the factory. If you are in high altitudes or wish to check the calibration:
- Bring a clean container of water to a boil.
- Carefully place the end of the thermometer probe into boiling water past the groove on the lower portion of stem. Leave immersed for at least one minute taking care not to let the probe rest on or make contact with the container.
- Boiling point will read 212 deg F/100 deg C at sea level. Boiling point decreases approx 2 deg with each 1000' of altitude. If the thermometer does not read 212 deg F/100 deg C at sea level, calibration can be reset by carefully holding the thermometer head and turning the hex nut with a wrench to move dial in one direction or the other.
- CAUTION - Do not adjust hot thermometer with bare hands!
- CAUTION - Do not hold thermometer with bare hands while placing in boiling water as burns can result!
- CAUTION - Thermometer tip is sharp, do not leave unattended or place within reach of children.
Select a Store
Selected Store
16 locations / In stock at 16
In stock at 15 other locations
Paris Ace Hardware
25907 Canal Rd
Orange beach, Al 36561
Paris Ace Hardware
1524 Gulf Shores Pkwy
Gulf Shores, AL 36542
Paris Ace Elberta
24753 State St
Elberta, AL 36530
Ace Hardware of West Pensacola
10800 W Highway 98
Pensacola, FL 32506
Ace Hardware of Gulf Breeze
(1 Review)
1131 Gulf Breeze Pkwy
Gulf Breeze, FL 32561
Ace Hardware of Pace
(2 Reviews)
4475 Woodbine Rd
Pace, FL 32571
Eastern Shore Ace Hardware
6530 Spanish Fort Blvd
Spanish Fort, AL 36527
Spring Hill Ace Hardware
4621 D Spring Hill Ave
Mobile, AL 36608
Racetrack Ace Hardware
(1 Review)
234 Racetrack Rd NE
Ft. Walton Beach, FL 32547
Andrews Ace Hardware
19750 N. 3rd St.
Citronelle, AL 36522
Consolidated Ace Hardware & Supply
702 North Ferdon Blvd
Crestview, FL 32536
Paris Ace Ocean Springs
2933 Bienville Blvd
Ocean Springs, MS 39564
Santa Rosa Ace Hardware
2202 US Hwy 98 W
Santa Rosa Beach, FL 32459
Paris Ace Foley
1100 S McKenzie St
Foley, AL 36535
Paris Ace Cottage Hill
7101 Cottage Hill Rd
Mobile, AL 36695
Bay Breeze Patio
32 Forest Shore Drive
Destin, FL 32550
Directions
Contact
Website
Product Information
This high quality, stainless steel temperature gauge - with a large, easy-to-read 3 inch dial - precisely monitors the temperatures inside the dome of an EGG, allowing you to achieve and maintain precise cooking temperatures Oversized 3 in (8 cm) Dial Stainless Steel External Temperature Gauge - 117250
- 750F deg / 400C deg
- Works with XXLarge, XLarge, Large, Medium, Small and MiniMax EGGs
- Heavy duty construction, hermetically sealed
- Designed and manufactured in the USA
Installation:
- Carefully insert stem from the outside through small hole in dome of the EGG; the silicone washer should remain on the outside of the EGG.
- Carefully reach inside the dome, and slide retaining clip onto the stem. Squeeze the clip so that it slides easily.
- Slide clip up the stem until the silicone washer -x001F-ts snugly against the exterior of the dome. For accurate reading, thermometer must be installed past the groove on the lower portion of stem as shown below.
This thermometer is calibrated and adjusted at the factory. If you are in high altitudes or wish to check the calibration:
- Bring a clean container of water to a boil.
- Carefully place the end of the thermometer probe into boiling water past the groove on the lower portion of stem. Leave immersed for at least one minute taking care not to let the probe rest on or make contact with the container.
- Boiling point will read 212 deg F/100 deg C at sea level. Boiling point decreases approx 2 deg with each 1000' of altitude. If the thermometer does not read 212 deg F/100 deg C at sea level, calibration can be reset by carefully holding the thermometer head and turning the hex nut with a wrench to move dial in one direction or the other.
- CAUTION - Do not adjust hot thermometer with bare hands!
- CAUTION - Do not hold thermometer with bare hands while placing in boiling water as burns can result!
- CAUTION - Thermometer tip is sharp, do not leave unattended or place within reach of children.
Product Reviews
There are no reviews yet for Big Green Egg: Temperature Gauge, 3 inch Dial .
Write a Review
