Skip to main content
Search
Big Green Egg

Temperature Gauge, 3 inch Dial in Mitchell, SD 57301

$29.99 USD
MSRP
Big Green Egg - Temperature Gauge, 3 inch Dial in Mitchell Sd 57301

Product Information

This high quality, stainless steel temperature gauge - with a large, easy-to-read 3 inch dial - precisely monitors the temperatures inside the dome of an EGG, allowing you to achieve and maintain precise cooking temperatures Oversized 3 in (8 cm) Dial Stainless Steel External Temperature Gauge - 117250

  • 750F deg / 400C deg
  • Works with XXLarge, XLarge, Large, Medium, Small and MiniMax EGGs
  • Heavy duty construction, hermetically sealed
  • Designed and manufactured in the USA

Installation:

  1. Carefully insert stem from the outside through small hole in dome of the EGG; the silicone washer should remain on the outside of the EGG.
  2. Carefully reach inside the dome, and slide retaining clip onto the stem. Squeeze the clip so that it slides easily.
  3. Slide clip up the stem until the silicone washer -x001F-ts snugly against the exterior of the dome. For accurate reading, thermometer must be installed past the groove on the lower portion of stem as shown below.

This thermometer is calibrated and adjusted at the factory. If you are in high altitudes or wish to check the calibration:

  1. Bring a clean container of water to a boil.
  2. Carefully place the end of the thermometer probe into boiling water past the groove on the lower portion of stem. Leave immersed for at least one minute taking care not to let the probe rest on or make contact with the container.
  3. Boiling point will read 212 deg F/100 deg C at sea level. Boiling point decreases approx 2 deg with each 1000' of altitude. If the thermometer does not read 212 deg F/100 deg C at sea level, calibration can be reset by carefully holding the thermometer head and turning the hex nut with a wrench to move dial in one direction or the other.
  • CAUTION - Do not adjust hot thermometer with bare hands!
  • CAUTION - Do not hold thermometer with bare hands while placing in boiling water as burns can result!
  • CAUTION - Thermometer tip is sharp, do not leave unattended or place within reach of children.

This item is in stock locally
Change Store

Select a Store

Selected Store

10 locations / In stock at 10

In stock at 9 other locations

In Stock

as of 2 hours ago

Madison Ace Hardware

800 Washington Ave S
Madison, SD 57042

50.0 mi

Pickup Available Now

In Stock

as of 2 hours ago

Hartford Ace Hardware

701 S Western Ave
Hartford, SD 57033

54.3 mi

Pickup Available Now

In Stock

as of 2 hours ago

Nyberg's Ace

7210 W 41st Street
Sioux Falls, SD 57106

62.3 mi

Pickup Available Now

In Stock

as of 2 hours ago

Tea Ace Hardware

701 N Heritage Pkwy
Tea, SD 57064

62.8 mi
Closed Open today at 7am

Pickup Available Now

In Stock

as of 2 hours ago

Nyberg's Ace Hardware

2500 W 12th Street
Sioux Falls, SD 57104

64.5 mi

Pickup Available Now

In Stock

as of 2 hours ago

Nyberg's Ace

607 S Sycamore Ave
Sioux Falls, SD 57103

68.9 mi

Pickup Available Now

In Stock

as of 2 hours ago

Brandon Ace Hardware

304 S Splitrock Blvd
Brandon, SD 57005

73.4 mi

Pickup Available Now

In Stock

as of 2 hours ago

Hefner Ace Hardware

201 E Main St
Bloomfield, NE 68718

79.2 mi

Pickup Available Now

In Stock

as of 2 hours ago

Vermillion Ace Hardware

812 Cottage Ave
Vermillion, SD 57069

84.2 mi

Pickup Available Now

Vermillion Ace Hardware

In Stock

as of 2 hours ago

Elfstrand's Ace Hardware

1420 Commerce St
Mitchell, SD 57301

1.2 mi

Product Information

This high quality, stainless steel temperature gauge - with a large, easy-to-read 3 inch dial - precisely monitors the temperatures inside the dome of an EGG, allowing you to achieve and maintain precise cooking temperatures Oversized 3 in (8 cm) Dial Stainless Steel External Temperature Gauge - 117250

  • 750F deg / 400C deg
  • Works with XXLarge, XLarge, Large, Medium, Small and MiniMax EGGs
  • Heavy duty construction, hermetically sealed
  • Designed and manufactured in the USA

Installation:

  1. Carefully insert stem from the outside through small hole in dome of the EGG; the silicone washer should remain on the outside of the EGG.
  2. Carefully reach inside the dome, and slide retaining clip onto the stem. Squeeze the clip so that it slides easily.
  3. Slide clip up the stem until the silicone washer -x001F-ts snugly against the exterior of the dome. For accurate reading, thermometer must be installed past the groove on the lower portion of stem as shown below.

This thermometer is calibrated and adjusted at the factory. If you are in high altitudes or wish to check the calibration:

  1. Bring a clean container of water to a boil.
  2. Carefully place the end of the thermometer probe into boiling water past the groove on the lower portion of stem. Leave immersed for at least one minute taking care not to let the probe rest on or make contact with the container.
  3. Boiling point will read 212 deg F/100 deg C at sea level. Boiling point decreases approx 2 deg with each 1000' of altitude. If the thermometer does not read 212 deg F/100 deg C at sea level, calibration can be reset by carefully holding the thermometer head and turning the hex nut with a wrench to move dial in one direction or the other.
  • CAUTION - Do not adjust hot thermometer with bare hands!
  • CAUTION - Do not hold thermometer with bare hands while placing in boiling water as burns can result!
  • CAUTION - Thermometer tip is sharp, do not leave unattended or place within reach of children.

Product Reviews

There are no reviews yet for Big Green Egg: Temperature Gauge, 3 inch Dial .

Write a Review