Big Green Egg
Temperature Gauge, 3 inch Dial in Middlefield, OH 44062
MSRP
Product Information
This high quality, stainless steel temperature gauge - with a large, easy-to-read 3 inch dial - precisely monitors the temperatures inside the dome of an EGG, allowing you to achieve and maintain precise cooking temperatures Oversized 3 in (8 cm) Dial Stainless Steel External Temperature Gauge - 117250
- 750F deg / 400C deg
- Works with XXLarge, XLarge, Large, Medium, Small and MiniMax EGGs
- Heavy duty construction, hermetically sealed
- Designed and manufactured in the USA
Installation:
- Carefully insert stem from the outside through small hole in dome of the EGG; the silicone washer should remain on the outside of the EGG.
- Carefully reach inside the dome, and slide retaining clip onto the stem. Squeeze the clip so that it slides easily.
- Slide clip up the stem until the silicone washer -x001F-ts snugly against the exterior of the dome. For accurate reading, thermometer must be installed past the groove on the lower portion of stem as shown below.
This thermometer is calibrated and adjusted at the factory. If you are in high altitudes or wish to check the calibration:
- Bring a clean container of water to a boil.
- Carefully place the end of the thermometer probe into boiling water past the groove on the lower portion of stem. Leave immersed for at least one minute taking care not to let the probe rest on or make contact with the container.
- Boiling point will read 212 deg F/100 deg C at sea level. Boiling point decreases approx 2 deg with each 1000' of altitude. If the thermometer does not read 212 deg F/100 deg C at sea level, calibration can be reset by carefully holding the thermometer head and turning the hex nut with a wrench to move dial in one direction or the other.
- CAUTION - Do not adjust hot thermometer with bare hands!
- CAUTION - Do not hold thermometer with bare hands while placing in boiling water as burns can result!
- CAUTION - Thermometer tip is sharp, do not leave unattended or place within reach of children.
Select a Store
Selected Store
20 locations / In stock at 20
In stock at 19 other locations
E&H Ace Hardware
15651 W High Street
Middlefield, OH 44062
E&H Ace Hardware
16765 Chillicothe Rd
Chagrin Falls, OH 44023
Turney's Ace Hardware
12670 W. Geauga Plaza
Chesterland, OH 44026
Ace Hardware of Aurora
(1 Review)
55 Barrington Town Square Dr
Aurora, OH 44202
E&H Ace Hardware
5144 Wilson Mills Rd
Richmond Heights, OH 44143
Burger's Ace Hardware
17111 Chagrin Blvd
Shaker Heights, OH 44120
Hudson Ace Hardware
5824 Darrow Rd
Hudson, OH 44236
E&H Ace Hardware
6500 Brecksville Rd
Independence, OH 44131
E&H Ace Hardware
451 Boardman Canfield Rd
Boardman, OH 44512
E&H Hardware
3235 Manchester Rd
Akron, OH 44319
Village Ace Hardware
10395 Main Street
New Middletown, OH 44442
E&H Ace Hardware
27255 Detroit Rd
Westlake, OH 44145
E&H Ace Hardware - Medina
3626 Medina Rd
Medina, OH 44256
Shelly Glass
426 College Street
Wadsworth, OH 44281
E&H Ace Hardware
375 Lear Rd
Avon Lake, OH 44012
Alam's Home & Hardware Inc
2300 Hospital Dr
Aliquippa, PA 15001
Wexford Ace Hardware
11910 Perry Hwy
Wexford, PA 15090
Hartville Hardware Inc
1315 Edison Street
Hartville, OH 44632
Farm & Home Hardware
140 Center Street
Ashland, OH 44805
Buddy's Ace Hardware
(1 Review)
2830 Gracy Center Way
Coraopolis, PA 15108
Directions
Contact
Website
Product Information
This high quality, stainless steel temperature gauge - with a large, easy-to-read 3 inch dial - precisely monitors the temperatures inside the dome of an EGG, allowing you to achieve and maintain precise cooking temperatures Oversized 3 in (8 cm) Dial Stainless Steel External Temperature Gauge - 117250
- 750F deg / 400C deg
- Works with XXLarge, XLarge, Large, Medium, Small and MiniMax EGGs
- Heavy duty construction, hermetically sealed
- Designed and manufactured in the USA
Installation:
- Carefully insert stem from the outside through small hole in dome of the EGG; the silicone washer should remain on the outside of the EGG.
- Carefully reach inside the dome, and slide retaining clip onto the stem. Squeeze the clip so that it slides easily.
- Slide clip up the stem until the silicone washer -x001F-ts snugly against the exterior of the dome. For accurate reading, thermometer must be installed past the groove on the lower portion of stem as shown below.
This thermometer is calibrated and adjusted at the factory. If you are in high altitudes or wish to check the calibration:
- Bring a clean container of water to a boil.
- Carefully place the end of the thermometer probe into boiling water past the groove on the lower portion of stem. Leave immersed for at least one minute taking care not to let the probe rest on or make contact with the container.
- Boiling point will read 212 deg F/100 deg C at sea level. Boiling point decreases approx 2 deg with each 1000' of altitude. If the thermometer does not read 212 deg F/100 deg C at sea level, calibration can be reset by carefully holding the thermometer head and turning the hex nut with a wrench to move dial in one direction or the other.
- CAUTION - Do not adjust hot thermometer with bare hands!
- CAUTION - Do not hold thermometer with bare hands while placing in boiling water as burns can result!
- CAUTION - Thermometer tip is sharp, do not leave unattended or place within reach of children.
Product Reviews
There are no reviews yet for Big Green Egg: Temperature Gauge, 3 inch Dial .
Write a Review
