Skip to main content
Search
Big Green Egg

Temperature Gauge, 3 inch Dial in Hurricane, UT 84737

$29.99 USD
MSRP
Big Green Egg - Temperature Gauge, 3 inch Dial in Hurricane Ut 84737

Product Information

This high quality, stainless steel temperature gauge - with a large, easy-to-read 3 inch dial - precisely monitors the temperatures inside the dome of an EGG, allowing you to achieve and maintain precise cooking temperatures Oversized 3 in (8 cm) Dial Stainless Steel External Temperature Gauge - 117250

  • 750F deg / 400C deg
  • Works with XXLarge, XLarge, Large, Medium, Small and MiniMax EGGs
  • Heavy duty construction, hermetically sealed
  • Designed and manufactured in the USA

Installation:

  1. Carefully insert stem from the outside through small hole in dome of the EGG; the silicone washer should remain on the outside of the EGG.
  2. Carefully reach inside the dome, and slide retaining clip onto the stem. Squeeze the clip so that it slides easily.
  3. Slide clip up the stem until the silicone washer -x001F-ts snugly against the exterior of the dome. For accurate reading, thermometer must be installed past the groove on the lower portion of stem as shown below.

This thermometer is calibrated and adjusted at the factory. If you are in high altitudes or wish to check the calibration:

  1. Bring a clean container of water to a boil.
  2. Carefully place the end of the thermometer probe into boiling water past the groove on the lower portion of stem. Leave immersed for at least one minute taking care not to let the probe rest on or make contact with the container.
  3. Boiling point will read 212 deg F/100 deg C at sea level. Boiling point decreases approx 2 deg with each 1000' of altitude. If the thermometer does not read 212 deg F/100 deg C at sea level, calibration can be reset by carefully holding the thermometer head and turning the hex nut with a wrench to move dial in one direction or the other.
  • CAUTION - Do not adjust hot thermometer with bare hands!
  • CAUTION - Do not hold thermometer with bare hands while placing in boiling water as burns can result!
  • CAUTION - Thermometer tip is sharp, do not leave unattended or place within reach of children.

This item is in stock locally
Change Store

Select a Store

Selected Store

6 locations / In stock at 6

In stock at 5 other locations

In Stock

as of 1 day ago

Buck's Ace Hardware

90 South 1400 West
Hurricane, UT 84737

1.4 mi

Pickup Available Now

In Stock

as of 1 day ago

Hurst General Store

160 N Bluff Street
St. George, UT 84770

17.3 mi

Pickup Available Now

In Stock

as of 1 day ago

Buck's Ace Hardware

2220 Rachel Dr
Santa Clara, UT 84765

20.5 mi

Pickup Available Now

In Stock

as of 1 day ago

Cedar City Hurst Ace Hardware

165 S Main Street
Cedar City, UT 84720

36.7 mi

Pickup Available Now

In Stock

as of 1 day ago

Mesquite Lumber Ace Hardware

102 W Mesquite Blvd
Mesquite, NV 89027

50.1 mi

Pickup Available Now

In Stock

as of 1 day ago

Lincoln Ace Hardware

169 Clover St
Caliente, NV 89008

73.5 mi

Product Information

This high quality, stainless steel temperature gauge - with a large, easy-to-read 3 inch dial - precisely monitors the temperatures inside the dome of an EGG, allowing you to achieve and maintain precise cooking temperatures Oversized 3 in (8 cm) Dial Stainless Steel External Temperature Gauge - 117250

  • 750F deg / 400C deg
  • Works with XXLarge, XLarge, Large, Medium, Small and MiniMax EGGs
  • Heavy duty construction, hermetically sealed
  • Designed and manufactured in the USA

Installation:

  1. Carefully insert stem from the outside through small hole in dome of the EGG; the silicone washer should remain on the outside of the EGG.
  2. Carefully reach inside the dome, and slide retaining clip onto the stem. Squeeze the clip so that it slides easily.
  3. Slide clip up the stem until the silicone washer -x001F-ts snugly against the exterior of the dome. For accurate reading, thermometer must be installed past the groove on the lower portion of stem as shown below.

This thermometer is calibrated and adjusted at the factory. If you are in high altitudes or wish to check the calibration:

  1. Bring a clean container of water to a boil.
  2. Carefully place the end of the thermometer probe into boiling water past the groove on the lower portion of stem. Leave immersed for at least one minute taking care not to let the probe rest on or make contact with the container.
  3. Boiling point will read 212 deg F/100 deg C at sea level. Boiling point decreases approx 2 deg with each 1000' of altitude. If the thermometer does not read 212 deg F/100 deg C at sea level, calibration can be reset by carefully holding the thermometer head and turning the hex nut with a wrench to move dial in one direction or the other.
  • CAUTION - Do not adjust hot thermometer with bare hands!
  • CAUTION - Do not hold thermometer with bare hands while placing in boiling water as burns can result!
  • CAUTION - Thermometer tip is sharp, do not leave unattended or place within reach of children.

Product Reviews

There are no reviews yet for Big Green Egg: Temperature Gauge, 3 inch Dial .

Write a Review