Skip to main content
Search
Big Green Egg

Temperature Gauge, 3 inch Dial in Hernando, MS

$29.99 USD
MSRP
Big Green Egg - Temperature Gauge, 3 inch Dial in Hernando Ms

Product Information

This high quality, stainless steel temperature gauge - with a large, easy-to-read 3 inch dial - precisely monitors the temperatures inside the dome of an EGG, allowing you to achieve and maintain precise cooking temperatures Oversized 3 in (8 cm) Dial Stainless Steel External Temperature Gauge - 117250

  • 750F deg / 400C deg
  • Works with XXLarge, XLarge, Large, Medium, Small and MiniMax EGGs
  • Heavy duty construction, hermetically sealed
  • Designed and manufactured in the USA

Installation:

  1. Carefully insert stem from the outside through small hole in dome of the EGG; the silicone washer should remain on the outside of the EGG.
  2. Carefully reach inside the dome, and slide retaining clip onto the stem. Squeeze the clip so that it slides easily.
  3. Slide clip up the stem until the silicone washer -x001F-ts snugly against the exterior of the dome. For accurate reading, thermometer must be installed past the groove on the lower portion of stem as shown below.

This thermometer is calibrated and adjusted at the factory. If you are in high altitudes or wish to check the calibration:

  1. Bring a clean container of water to a boil.
  2. Carefully place the end of the thermometer probe into boiling water past the groove on the lower portion of stem. Leave immersed for at least one minute taking care not to let the probe rest on or make contact with the container.
  3. Boiling point will read 212 deg F/100 deg C at sea level. Boiling point decreases approx 2 deg with each 1000' of altitude. If the thermometer does not read 212 deg F/100 deg C at sea level, calibration can be reset by carefully holding the thermometer head and turning the hex nut with a wrench to move dial in one direction or the other.
  • CAUTION - Do not adjust hot thermometer with bare hands!
  • CAUTION - Do not hold thermometer with bare hands while placing in boiling water as burns can result!
  • CAUTION - Thermometer tip is sharp, do not leave unattended or place within reach of children.

This item is in stock locally
Change Store

Select a Store

Selected Store

8 locations / In stock at 8

In stock at 7 other locations

In Stock

as of 1 hour ago

Cordova Ace Hardware

1740 N Germantown Pkwy
Cordova, TN 38016

26.7 mi

Pickup Available Now

In Stock

as of 59 minutes ago

Shaw Ace Hardware

1400 University Ave
Oxford, MS 38655

41.8 mi

Pickup Available Now

In Stock

as of 1 hour ago

Gazaway Ace Hilltop

4827 E. Johnson
Jonesboro, AR 72401

80.4 mi

Pickup Available Now

In Stock

as of 1 hour ago

Cleveland Home & Hardware

401 First Street
Cleveland, MS 38732

85.0 mi

Pickup Available Now

In Stock

Complete Home Center

32 East Commerce St
Hernando, MS 38632

0.3 mi
Open

In Stock

as of 60 minutes ago

Ace Hardware of Arlington

11801 Crawford Pines Dr
Arlington, TN 38002

35.8 mi

In Stock

as of 1 hour ago

McClendon Ace Hardware

103 Dawson St
Marked Tree, AR 72365

54.2 mi

In Stock

as of 7 hours ago

DNW Outdoors

1711 East Parker Rd
Jonesboro, AR 72404

78.4 mi
Open
DNW Outdoors

Product Information

This high quality, stainless steel temperature gauge - with a large, easy-to-read 3 inch dial - precisely monitors the temperatures inside the dome of an EGG, allowing you to achieve and maintain precise cooking temperatures Oversized 3 in (8 cm) Dial Stainless Steel External Temperature Gauge - 117250

  • 750F deg / 400C deg
  • Works with XXLarge, XLarge, Large, Medium, Small and MiniMax EGGs
  • Heavy duty construction, hermetically sealed
  • Designed and manufactured in the USA

Installation:

  1. Carefully insert stem from the outside through small hole in dome of the EGG; the silicone washer should remain on the outside of the EGG.
  2. Carefully reach inside the dome, and slide retaining clip onto the stem. Squeeze the clip so that it slides easily.
  3. Slide clip up the stem until the silicone washer -x001F-ts snugly against the exterior of the dome. For accurate reading, thermometer must be installed past the groove on the lower portion of stem as shown below.

This thermometer is calibrated and adjusted at the factory. If you are in high altitudes or wish to check the calibration:

  1. Bring a clean container of water to a boil.
  2. Carefully place the end of the thermometer probe into boiling water past the groove on the lower portion of stem. Leave immersed for at least one minute taking care not to let the probe rest on or make contact with the container.
  3. Boiling point will read 212 deg F/100 deg C at sea level. Boiling point decreases approx 2 deg with each 1000' of altitude. If the thermometer does not read 212 deg F/100 deg C at sea level, calibration can be reset by carefully holding the thermometer head and turning the hex nut with a wrench to move dial in one direction or the other.
  • CAUTION - Do not adjust hot thermometer with bare hands!
  • CAUTION - Do not hold thermometer with bare hands while placing in boiling water as burns can result!
  • CAUTION - Thermometer tip is sharp, do not leave unattended or place within reach of children.

Product Reviews

There are no reviews yet for Big Green Egg: Temperature Gauge, 3 inch Dial .

Write a Review