Big Green Egg
Temperature Gauge, 3 inch Dial in Gridley, CA 95948
MSRP
Product Information
This high quality, stainless steel temperature gauge - with a large, easy-to-read 3 inch dial - precisely monitors the temperatures inside the dome of an EGG, allowing you to achieve and maintain precise cooking temperatures Oversized 3 in (8 cm) Dial Stainless Steel External Temperature Gauge - 117250
- 750F deg / 400C deg
- Works with XXLarge, XLarge, Large, Medium, Small and MiniMax EGGs
- Heavy duty construction, hermetically sealed
- Designed and manufactured in the USA
Installation:
- Carefully insert stem from the outside through small hole in dome of the EGG; the silicone washer should remain on the outside of the EGG.
- Carefully reach inside the dome, and slide retaining clip onto the stem. Squeeze the clip so that it slides easily.
- Slide clip up the stem until the silicone washer -x001F-ts snugly against the exterior of the dome. For accurate reading, thermometer must be installed past the groove on the lower portion of stem as shown below.
This thermometer is calibrated and adjusted at the factory. If you are in high altitudes or wish to check the calibration:
- Bring a clean container of water to a boil.
- Carefully place the end of the thermometer probe into boiling water past the groove on the lower portion of stem. Leave immersed for at least one minute taking care not to let the probe rest on or make contact with the container.
- Boiling point will read 212 deg F/100 deg C at sea level. Boiling point decreases approx 2 deg with each 1000' of altitude. If the thermometer does not read 212 deg F/100 deg C at sea level, calibration can be reset by carefully holding the thermometer head and turning the hex nut with a wrench to move dial in one direction or the other.
- CAUTION - Do not adjust hot thermometer with bare hands!
- CAUTION - Do not hold thermometer with bare hands while placing in boiling water as burns can result!
- CAUTION - Thermometer tip is sharp, do not leave unattended or place within reach of children.
Select a Store
Selected Store
20 locations / In stock at 20
In stock at 19 other locations
Candelario Ace Hardware
1626 State Hwy 99
Gridley, CA 95948
Stinemans Farm Supply
4505 Wheatland Rd
Wheatland, CA 95692
Westlake Ace Hardware
231 West East Ave
Chico, CA 95926
Alsco Geyer Ace
255 N Tehema St
Willows, CA 95988
Hills Flat Lumber - Grass Valley
380 Railroad Ave
Grass Valley, CA 95945
Orland Ace Hardware
820 5th Street
Orland, CA 95963
Hills Flat Lumber - Colfax
1000 South Canyon Way
Colfax, CA 95713
Westlake Ace Hardware #149
1350 E Main Street
Woodland, CA 95776
Roseville Ace Hardware
(1 Review)
108A Harding Blvd
Roseville, CA 95678
Granite Bay Ace Hardware
8665 Auburn Folsom Rd.
Granite Bay, CA 95746
American River Ace Hardware
9500 Greenback Lane
Folsom, CA 95630
East Sacramento Ace Hardware
5030 Folsom Blvd
Sacramento, CA 95819
Red Bluff Ace Hardware
22690 Antelope Blvd
Red Bluff, CA 96080
Dixon Ace Hardware & Lumber
1505 N 1st Street
Dixon, CA 95620
Elk Grove Ace Hardware
9680 Bruceville Rd
Elk Grove, CA 95757
Suisun Ace Hardware
250 STE I Sunset Ave
Suisun City, CA 94585
Garrett Ace Hardware
1340 Healdsburg Ave
Healdsburg, CA 95448
Garrett Ace Hardware
10540 Old Redwood Hwy
Windsor, CA 95492
Better Deal Exchange
1845 Mitchell Ave
Oroville, CA 95966
Miller's Ace Hardware
8077 Madison Ave
Citrus Heights, CA 95610
Directions
Contact
Website
Product Information
This high quality, stainless steel temperature gauge - with a large, easy-to-read 3 inch dial - precisely monitors the temperatures inside the dome of an EGG, allowing you to achieve and maintain precise cooking temperatures Oversized 3 in (8 cm) Dial Stainless Steel External Temperature Gauge - 117250
- 750F deg / 400C deg
- Works with XXLarge, XLarge, Large, Medium, Small and MiniMax EGGs
- Heavy duty construction, hermetically sealed
- Designed and manufactured in the USA
Installation:
- Carefully insert stem from the outside through small hole in dome of the EGG; the silicone washer should remain on the outside of the EGG.
- Carefully reach inside the dome, and slide retaining clip onto the stem. Squeeze the clip so that it slides easily.
- Slide clip up the stem until the silicone washer -x001F-ts snugly against the exterior of the dome. For accurate reading, thermometer must be installed past the groove on the lower portion of stem as shown below.
This thermometer is calibrated and adjusted at the factory. If you are in high altitudes or wish to check the calibration:
- Bring a clean container of water to a boil.
- Carefully place the end of the thermometer probe into boiling water past the groove on the lower portion of stem. Leave immersed for at least one minute taking care not to let the probe rest on or make contact with the container.
- Boiling point will read 212 deg F/100 deg C at sea level. Boiling point decreases approx 2 deg with each 1000' of altitude. If the thermometer does not read 212 deg F/100 deg C at sea level, calibration can be reset by carefully holding the thermometer head and turning the hex nut with a wrench to move dial in one direction or the other.
- CAUTION - Do not adjust hot thermometer with bare hands!
- CAUTION - Do not hold thermometer with bare hands while placing in boiling water as burns can result!
- CAUTION - Thermometer tip is sharp, do not leave unattended or place within reach of children.
Product Reviews
There are no reviews yet for Big Green Egg: Temperature Gauge, 3 inch Dial .
Write a Review
