Big Green Egg
Temperature Gauge, 3 inch Dial in Gray, TN 37615
MSRP
Product Information
This high quality, stainless steel temperature gauge - with a large, easy-to-read 3 inch dial - precisely monitors the temperatures inside the dome of an EGG, allowing you to achieve and maintain precise cooking temperatures Oversized 3 in (8 cm) Dial Stainless Steel External Temperature Gauge - 117250
- 750F deg / 400C deg
- Works with XXLarge, XLarge, Large, Medium, Small and MiniMax EGGs
- Heavy duty construction, hermetically sealed
- Designed and manufactured in the USA
Installation:
- Carefully insert stem from the outside through small hole in dome of the EGG; the silicone washer should remain on the outside of the EGG.
- Carefully reach inside the dome, and slide retaining clip onto the stem. Squeeze the clip so that it slides easily.
- Slide clip up the stem until the silicone washer -x001F-ts snugly against the exterior of the dome. For accurate reading, thermometer must be installed past the groove on the lower portion of stem as shown below.
This thermometer is calibrated and adjusted at the factory. If you are in high altitudes or wish to check the calibration:
- Bring a clean container of water to a boil.
- Carefully place the end of the thermometer probe into boiling water past the groove on the lower portion of stem. Leave immersed for at least one minute taking care not to let the probe rest on or make contact with the container.
- Boiling point will read 212 deg F/100 deg C at sea level. Boiling point decreases approx 2 deg with each 1000' of altitude. If the thermometer does not read 212 deg F/100 deg C at sea level, calibration can be reset by carefully holding the thermometer head and turning the hex nut with a wrench to move dial in one direction or the other.
- CAUTION - Do not adjust hot thermometer with bare hands!
- CAUTION - Do not hold thermometer with bare hands while placing in boiling water as burns can result!
- CAUTION - Thermometer tip is sharp, do not leave unattended or place within reach of children.
Select a Store
Selected Store
20 locations / In stock at 20
In stock at 19 other locations
Curt's Ace Hardware
251 Old Gray Station Rd
Gray, TN 37615
Curt's Ace Hardware
6634 Bristol Hwy
Piney Flats, TN 37686
Curt's Ace Hardware
1460 Euclid Ave
Bristol, VA 24201
Young Ace Hardware of Weaverville
(3 Reviews)
136 Weaver Blvd
Weaverville, NC 28787
Curt's Ace Hardware
232 W Broadway
Newport, TN 37821
Young Ace Hardware of North Asheville
(1 Review)
812 Merrimon Ave
Asheville, NC 28804
Madden's Ace Hardware
1070 Haywood Rd
West Asheville, NC 28806
Madden's Ace Hardware - East Asheville
800 Fairview Rd
Asheville, NC 28803
Young Ace Hardware of Enka-Candler
10 Westridge Market Place
Candler, NC 28715
Young Ace Hardware of South Asheville
1900 Hendersonville Rd
Asheville, NC 28803
Northwest Ace Hardware-Morganton
526 W Fleming Dr
Morganton, NC 28655
Haywood Ace Hardware
1391 Dellwood Rd
Waynesville, NC 28786
Young Ace Hardware of Mill River
3340 Boylston Hwy
Mills River, NC 28759
Carolina Ace Hardware
911 Greenville Hwy
Hendersonville, NC 28792
Ace Hardware Hickory
9433 NC Hwy 127
Hickory, NC 28601
Northwest Hardware - Hickory
3347 S NC 127 Hwy
Hickory, NC 28602
Elder's Ace Hardware of Halls
6950 Maynardville Pike
Knoxville, TN 37918
Curt's Ace Hardware
120 Cook St
Abingdon, VA 24210
Curt's Ace Hardware
1094 E Main Street
Lebanon, VA 24266
Curt's Ace Hardware
7516 Asheville Hwy
Knoxville, TN 37924
Directions
Contact
Product Information
This high quality, stainless steel temperature gauge - with a large, easy-to-read 3 inch dial - precisely monitors the temperatures inside the dome of an EGG, allowing you to achieve and maintain precise cooking temperatures Oversized 3 in (8 cm) Dial Stainless Steel External Temperature Gauge - 117250
- 750F deg / 400C deg
- Works with XXLarge, XLarge, Large, Medium, Small and MiniMax EGGs
- Heavy duty construction, hermetically sealed
- Designed and manufactured in the USA
Installation:
- Carefully insert stem from the outside through small hole in dome of the EGG; the silicone washer should remain on the outside of the EGG.
- Carefully reach inside the dome, and slide retaining clip onto the stem. Squeeze the clip so that it slides easily.
- Slide clip up the stem until the silicone washer -x001F-ts snugly against the exterior of the dome. For accurate reading, thermometer must be installed past the groove on the lower portion of stem as shown below.
This thermometer is calibrated and adjusted at the factory. If you are in high altitudes or wish to check the calibration:
- Bring a clean container of water to a boil.
- Carefully place the end of the thermometer probe into boiling water past the groove on the lower portion of stem. Leave immersed for at least one minute taking care not to let the probe rest on or make contact with the container.
- Boiling point will read 212 deg F/100 deg C at sea level. Boiling point decreases approx 2 deg with each 1000' of altitude. If the thermometer does not read 212 deg F/100 deg C at sea level, calibration can be reset by carefully holding the thermometer head and turning the hex nut with a wrench to move dial in one direction or the other.
- CAUTION - Do not adjust hot thermometer with bare hands!
- CAUTION - Do not hold thermometer with bare hands while placing in boiling water as burns can result!
- CAUTION - Thermometer tip is sharp, do not leave unattended or place within reach of children.
Product Reviews
There are no reviews yet for Big Green Egg: Temperature Gauge, 3 inch Dial .
Write a Review
