Big Green Egg
Temperature Gauge, 3 inch Dial in Fulton, MO 65251
MSRP
Product Information
This high quality, stainless steel temperature gauge - with a large, easy-to-read 3 inch dial - precisely monitors the temperatures inside the dome of an EGG, allowing you to achieve and maintain precise cooking temperatures Oversized 3 in (8 cm) Dial Stainless Steel External Temperature Gauge - 117250
- 750F deg / 400C deg
- Works with XXLarge, XLarge, Large, Medium, Small and MiniMax EGGs
- Heavy duty construction, hermetically sealed
- Designed and manufactured in the USA
Installation:
- Carefully insert stem from the outside through small hole in dome of the EGG; the silicone washer should remain on the outside of the EGG.
- Carefully reach inside the dome, and slide retaining clip onto the stem. Squeeze the clip so that it slides easily.
- Slide clip up the stem until the silicone washer -x001F-ts snugly against the exterior of the dome. For accurate reading, thermometer must be installed past the groove on the lower portion of stem as shown below.
This thermometer is calibrated and adjusted at the factory. If you are in high altitudes or wish to check the calibration:
- Bring a clean container of water to a boil.
- Carefully place the end of the thermometer probe into boiling water past the groove on the lower portion of stem. Leave immersed for at least one minute taking care not to let the probe rest on or make contact with the container.
- Boiling point will read 212 deg F/100 deg C at sea level. Boiling point decreases approx 2 deg with each 1000' of altitude. If the thermometer does not read 212 deg F/100 deg C at sea level, calibration can be reset by carefully holding the thermometer head and turning the hex nut with a wrench to move dial in one direction or the other.
- CAUTION - Do not adjust hot thermometer with bare hands!
- CAUTION - Do not hold thermometer with bare hands while placing in boiling water as burns can result!
- CAUTION - Thermometer tip is sharp, do not leave unattended or place within reach of children.
Select a Store
Selected Store
19 locations / In stock at 19
In stock at 18 other locations
Westlake ACE Hardware #3
(1 Review)
206 E Second St
Fulton, MO 65251
Westlake Hardware 9
700 West Jackson
Mexico, MO 65265
Westlake Hardware 6
2305 Missouri Blvd
Jefferson City, MO 65101
Westlake Hardware 2
1910 W Worley
Columbia, MO 65203
Westlake Hardware #1
1919 N Moberly Street
Moberly, MO 65270
Westlake Hardware 72
810 Washington Corners
Washington, MO 63090
Porters Ace Osage Beach
4627 Osage Beach Pkwy
Osage Beach, MO 65065
Westlake Ace Hardware #7
1404 N Missouri St
Macon, MO 63552
Hackmann Lumber & Home Center
625 South 4th Street
Pacific, MO 63069
Westlake Ace Hardware 12
1010 Thompson Blvd
Sedalia, MO 65301
Westlake Ace Hardware
915 Jungermann Rd
St. Peters, MO 63376
Cotton's Ace Hardware
111 Hilltop Village Center Dr
Eureka, MO 63025
Rick's Ace Hardware
15870 Clayton Rd
Ellisville, MO 63011
Rick's Ace Hardware
221 Lamp and Lantern Village
Chesterfield, MO 63017
Great Lakes Ace Hardware
901 W Fayette St
Pittsfield, IL 62363
Westlake Hardware
12634 Dorsett Rd
Maryland Heights, MO 63043
Niemann's Ace Hardware - Quincy
(1 Review)
1637 Broadway St
Quincy, IL 62301
Westlake Hardware
505 E Nifong Blvd
Columbia, MO 65201
Westlake Ace Hardware 170
1144 Meramec Station Rd
Ballwin, MO 63021
Directions
Contact
Website
Product Information
This high quality, stainless steel temperature gauge - with a large, easy-to-read 3 inch dial - precisely monitors the temperatures inside the dome of an EGG, allowing you to achieve and maintain precise cooking temperatures Oversized 3 in (8 cm) Dial Stainless Steel External Temperature Gauge - 117250
- 750F deg / 400C deg
- Works with XXLarge, XLarge, Large, Medium, Small and MiniMax EGGs
- Heavy duty construction, hermetically sealed
- Designed and manufactured in the USA
Installation:
- Carefully insert stem from the outside through small hole in dome of the EGG; the silicone washer should remain on the outside of the EGG.
- Carefully reach inside the dome, and slide retaining clip onto the stem. Squeeze the clip so that it slides easily.
- Slide clip up the stem until the silicone washer -x001F-ts snugly against the exterior of the dome. For accurate reading, thermometer must be installed past the groove on the lower portion of stem as shown below.
This thermometer is calibrated and adjusted at the factory. If you are in high altitudes or wish to check the calibration:
- Bring a clean container of water to a boil.
- Carefully place the end of the thermometer probe into boiling water past the groove on the lower portion of stem. Leave immersed for at least one minute taking care not to let the probe rest on or make contact with the container.
- Boiling point will read 212 deg F/100 deg C at sea level. Boiling point decreases approx 2 deg with each 1000' of altitude. If the thermometer does not read 212 deg F/100 deg C at sea level, calibration can be reset by carefully holding the thermometer head and turning the hex nut with a wrench to move dial in one direction or the other.
- CAUTION - Do not adjust hot thermometer with bare hands!
- CAUTION - Do not hold thermometer with bare hands while placing in boiling water as burns can result!
- CAUTION - Thermometer tip is sharp, do not leave unattended or place within reach of children.
Product Reviews
There are no reviews yet for Big Green Egg: Temperature Gauge, 3 inch Dial .
Write a Review
