Big Green Egg
Temperature Gauge, 3 inch Dial in Fishers, IN
MSRP
Product Information
This high quality, stainless steel temperature gauge - with a large, easy-to-read 3 inch dial - precisely monitors the temperatures inside the dome of an EGG, allowing you to achieve and maintain precise cooking temperatures Oversized 3 in (8 cm) Dial Stainless Steel External Temperature Gauge - 117250
- 750F deg / 400C deg
- Works with XXLarge, XLarge, Large, Medium, Small and MiniMax EGGs
- Heavy duty construction, hermetically sealed
- Designed and manufactured in the USA
Installation:
- Carefully insert stem from the outside through small hole in dome of the EGG; the silicone washer should remain on the outside of the EGG.
- Carefully reach inside the dome, and slide retaining clip onto the stem. Squeeze the clip so that it slides easily.
- Slide clip up the stem until the silicone washer -x001F-ts snugly against the exterior of the dome. For accurate reading, thermometer must be installed past the groove on the lower portion of stem as shown below.
This thermometer is calibrated and adjusted at the factory. If you are in high altitudes or wish to check the calibration:
- Bring a clean container of water to a boil.
- Carefully place the end of the thermometer probe into boiling water past the groove on the lower portion of stem. Leave immersed for at least one minute taking care not to let the probe rest on or make contact with the container.
- Boiling point will read 212 deg F/100 deg C at sea level. Boiling point decreases approx 2 deg with each 1000' of altitude. If the thermometer does not read 212 deg F/100 deg C at sea level, calibration can be reset by carefully holding the thermometer head and turning the hex nut with a wrench to move dial in one direction or the other.
- CAUTION - Do not adjust hot thermometer with bare hands!
- CAUTION - Do not hold thermometer with bare hands while placing in boiling water as burns can result!
- CAUTION - Thermometer tip is sharp, do not leave unattended or place within reach of children.
Select a Store
Selected Store
21 locations / In stock at 21
In stock at 20 other locations
White's Ace Hardware Carmel - Geist
10941 E 79th St
Indianapolis, IN 46236
Great Lakes Ace Hardware
11581 Geist Pavilion Drive
Fishers, IN 46037
White's Ace Hardware Carmel
731 S Rangeline Rd
Carmel, IN 46032
Westfield Ace Hardware
3400 Nancy St
Westfield, IN 46074
Walker Ace
4083 South Arbor Lane
New Palestine, IN 46163
Great Lakes Ace
1240 N State St
Greenfield, IN 46140
County Line Ace
8904 S Meridian St
Indianapolis, IN 46217
Great Lakes Ace Hardware
(1 Review)
1800 E Main St
Plainfield, IN 46168
Greenwood Ace
2101 Independence Drive
Greenwood, IN 46143
Martinsville Ace Hardware
(1 Review)
2064 Burton Lane
Martinsville, IN 46151
Stevenson's Ace Hardware
1812 US 231 S
Crawfordsville, IN 47933
Ace Hardware - Lafayette
119 Beck Lane
Lafayette, IN 47909
Ace Hardware West Lafayette
1194 Sagamore Pkwy W
West Lafayette, IN 47906
Monticello Ace Hardware
918 N Main Street
Monticello, IN 47960
Smith Farm Stores, Inc.
151 Rochester Plaza
Rochester, IN 46975
Sycamore Hardware
2800 Poplar St
Terre Haute, IN 47803
Decatur Ace Hardware
1220 S 13th Street
Decatur, IN 46733
Great Lakes Ace Hardware
25 Boone Village
Zionsville, IN 46077
Benge's Ace Hardware
2806 Nichol Ave
Anderson, IN 46011
Powell Ace Home Center
2492 W US Hwy 136
Covington, IN 47932
Versailles Ace Hardware
337 Marker Rd
Versailles, OH 45380
Directions
Contact
Website
Product Information
This high quality, stainless steel temperature gauge - with a large, easy-to-read 3 inch dial - precisely monitors the temperatures inside the dome of an EGG, allowing you to achieve and maintain precise cooking temperatures Oversized 3 in (8 cm) Dial Stainless Steel External Temperature Gauge - 117250
- 750F deg / 400C deg
- Works with XXLarge, XLarge, Large, Medium, Small and MiniMax EGGs
- Heavy duty construction, hermetically sealed
- Designed and manufactured in the USA
Installation:
- Carefully insert stem from the outside through small hole in dome of the EGG; the silicone washer should remain on the outside of the EGG.
- Carefully reach inside the dome, and slide retaining clip onto the stem. Squeeze the clip so that it slides easily.
- Slide clip up the stem until the silicone washer -x001F-ts snugly against the exterior of the dome. For accurate reading, thermometer must be installed past the groove on the lower portion of stem as shown below.
This thermometer is calibrated and adjusted at the factory. If you are in high altitudes or wish to check the calibration:
- Bring a clean container of water to a boil.
- Carefully place the end of the thermometer probe into boiling water past the groove on the lower portion of stem. Leave immersed for at least one minute taking care not to let the probe rest on or make contact with the container.
- Boiling point will read 212 deg F/100 deg C at sea level. Boiling point decreases approx 2 deg with each 1000' of altitude. If the thermometer does not read 212 deg F/100 deg C at sea level, calibration can be reset by carefully holding the thermometer head and turning the hex nut with a wrench to move dial in one direction or the other.
- CAUTION - Do not adjust hot thermometer with bare hands!
- CAUTION - Do not hold thermometer with bare hands while placing in boiling water as burns can result!
- CAUTION - Thermometer tip is sharp, do not leave unattended or place within reach of children.
Product Reviews
There are no reviews yet for Big Green Egg: Temperature Gauge, 3 inch Dial .
Write a Review
