Big Green Egg
Temperature Gauge, 3 inch Dial in Dunn, NC 28334
MSRP
Product Information
This high quality, stainless steel temperature gauge - with a large, easy-to-read 3 inch dial - precisely monitors the temperatures inside the dome of an EGG, allowing you to achieve and maintain precise cooking temperatures Oversized 3 in (8 cm) Dial Stainless Steel External Temperature Gauge - 117250
- 750F deg / 400C deg
- Works with XXLarge, XLarge, Large, Medium, Small and MiniMax EGGs
- Heavy duty construction, hermetically sealed
- Designed and manufactured in the USA
Installation:
- Carefully insert stem from the outside through small hole in dome of the EGG; the silicone washer should remain on the outside of the EGG.
- Carefully reach inside the dome, and slide retaining clip onto the stem. Squeeze the clip so that it slides easily.
- Slide clip up the stem until the silicone washer -x001F-ts snugly against the exterior of the dome. For accurate reading, thermometer must be installed past the groove on the lower portion of stem as shown below.
This thermometer is calibrated and adjusted at the factory. If you are in high altitudes or wish to check the calibration:
- Bring a clean container of water to a boil.
- Carefully place the end of the thermometer probe into boiling water past the groove on the lower portion of stem. Leave immersed for at least one minute taking care not to let the probe rest on or make contact with the container.
- Boiling point will read 212 deg F/100 deg C at sea level. Boiling point decreases approx 2 deg with each 1000' of altitude. If the thermometer does not read 212 deg F/100 deg C at sea level, calibration can be reset by carefully holding the thermometer head and turning the hex nut with a wrench to move dial in one direction or the other.
- CAUTION - Do not adjust hot thermometer with bare hands!
- CAUTION - Do not hold thermometer with bare hands while placing in boiling water as burns can result!
- CAUTION - Thermometer tip is sharp, do not leave unattended or place within reach of children.
Select a Store
Selected Store
24 locations / In stock at 24
In stock at 23 other locations
Cleveland Ace Hardware
7277 NC Hwy 42 NW
Raleigh, NC 27603
Grantham Ace Hardware
3396 US Hwy 13 South
Goldsboro, NC 27530
Westlake Ace Hardware - Cary
2976 Kildaire Farm Rd.
Cary, NC 27518
Westlake Ace Hardware #132
802 Semart Dr Suite 112
Raleigh, NC 27604
Westlake Ace Hardware #111
6196-100 Falls of Neuse Rd
Raleigh, NC 27609
Farmer's Hardware
107 F Mollie Dr
Goldsboro, NC 27534
Westlake Ace Hardware #112
10930-101 Raven Ridge Rd
Raleigh, NC 27614
Westlake Ace Hardware-Chapel Hill
157 Chatham Downs Dr
Chapel Hill, NC 27517
Triangle Ace Hardware
4711 Hope Valley Rd
Durham, NC 27707
Bells Ace Hardware & Outdoor Power Equipment
700 E Washington St
Nashville, NC 27856
Ace Home Center - Tarboro
1713 North Main St
Tarboro, NC 27886
Stoney Creek Ace Hardware
941 Center Crest Dr
Whitsett, NC 27377
Stevens Ace Hardware
1831 Dawson St
Wilmington, NC 28403
Steven's Ace Hardware
6756 Market Street
Wilmington, NC 28405
McLamb's Ace Hardware
1002 W Cumberland St
Dunn, NC 28334
Lori's Ace Hardware
2800 Raeford Rd
Fayetteville, NC 28303
Westlake Ace Hardware
1080 N Rogers Lane
Raleigh, NC 27610
Lake Boone Ace Hardware
2462 Wycliff Rd
Raleigh, NC 27607
Westlake Ace-Pinecrest
9101 Leesville Rd
Raleigh, NC 27613
McLamb Ace of Kenansville
304 S Main Street
Kenansville, NC 28349
Southern Pines Ace
215 Capital Dr
Carthage, NC 28327
Oxford Ace Hardware
119 Hillsboro St
Oxford, NC 27565
Cross Ace Hardware
1040 Henderson Dr
Jacksonville, NC 28540
Lori's Ace Home & Hardware
14021 NC Hwy 50
Surf City, NC 28445
Product Information
This high quality, stainless steel temperature gauge - with a large, easy-to-read 3 inch dial - precisely monitors the temperatures inside the dome of an EGG, allowing you to achieve and maintain precise cooking temperatures Oversized 3 in (8 cm) Dial Stainless Steel External Temperature Gauge - 117250
- 750F deg / 400C deg
- Works with XXLarge, XLarge, Large, Medium, Small and MiniMax EGGs
- Heavy duty construction, hermetically sealed
- Designed and manufactured in the USA
Installation:
- Carefully insert stem from the outside through small hole in dome of the EGG; the silicone washer should remain on the outside of the EGG.
- Carefully reach inside the dome, and slide retaining clip onto the stem. Squeeze the clip so that it slides easily.
- Slide clip up the stem until the silicone washer -x001F-ts snugly against the exterior of the dome. For accurate reading, thermometer must be installed past the groove on the lower portion of stem as shown below.
This thermometer is calibrated and adjusted at the factory. If you are in high altitudes or wish to check the calibration:
- Bring a clean container of water to a boil.
- Carefully place the end of the thermometer probe into boiling water past the groove on the lower portion of stem. Leave immersed for at least one minute taking care not to let the probe rest on or make contact with the container.
- Boiling point will read 212 deg F/100 deg C at sea level. Boiling point decreases approx 2 deg with each 1000' of altitude. If the thermometer does not read 212 deg F/100 deg C at sea level, calibration can be reset by carefully holding the thermometer head and turning the hex nut with a wrench to move dial in one direction or the other.
- CAUTION - Do not adjust hot thermometer with bare hands!
- CAUTION - Do not hold thermometer with bare hands while placing in boiling water as burns can result!
- CAUTION - Thermometer tip is sharp, do not leave unattended or place within reach of children.
Product Reviews
There are no reviews yet for Big Green Egg: Temperature Gauge, 3 inch Dial .
Write a Review