Big Green Egg
Temperature Gauge, 3 inch Dial in Dover, NH 03820
MSRP
Product Information
This high quality, stainless steel temperature gauge - with a large, easy-to-read 3 inch dial - precisely monitors the temperatures inside the dome of an EGG, allowing you to achieve and maintain precise cooking temperatures Oversized 3 in (8 cm) Dial Stainless Steel External Temperature Gauge - 117250
- 750F deg / 400C deg
- Works with XXLarge, XLarge, Large, Medium, Small and MiniMax EGGs
- Heavy duty construction, hermetically sealed
- Designed and manufactured in the USA
Installation:
- Carefully insert stem from the outside through small hole in dome of the EGG; the silicone washer should remain on the outside of the EGG.
- Carefully reach inside the dome, and slide retaining clip onto the stem. Squeeze the clip so that it slides easily.
- Slide clip up the stem until the silicone washer -x001F-ts snugly against the exterior of the dome. For accurate reading, thermometer must be installed past the groove on the lower portion of stem as shown below.
This thermometer is calibrated and adjusted at the factory. If you are in high altitudes or wish to check the calibration:
- Bring a clean container of water to a boil.
- Carefully place the end of the thermometer probe into boiling water past the groove on the lower portion of stem. Leave immersed for at least one minute taking care not to let the probe rest on or make contact with the container.
- Boiling point will read 212 deg F/100 deg C at sea level. Boiling point decreases approx 2 deg with each 1000' of altitude. If the thermometer does not read 212 deg F/100 deg C at sea level, calibration can be reset by carefully holding the thermometer head and turning the hex nut with a wrench to move dial in one direction or the other.
- CAUTION - Do not adjust hot thermometer with bare hands!
- CAUTION - Do not hold thermometer with bare hands while placing in boiling water as burns can result!
- CAUTION - Thermometer tip is sharp, do not leave unattended or place within reach of children.
Select a Store
Selected Store
46 locations / In stock at 46
In stock at 45 other locations
Rocky's Ace Hardware
873 Central Ave #108
Dover, NH 03820
Kittery Ace Hardware
6 Shapleigh Rd
Kittery, ME 03904
Rocky's Ace Hardware
20 Loudon Road
Concord, NH 03301
Plummer's Ace Hardware
42 Central Ave
Limerick, ME 04048
Rocky's Ace Hardware
50 Peters Street
North Andover, MA 01845
Oak Hill Ace Hardware
29 Gorham Rd
Scarborough, ME 04074
Dawson's Ace Hardware
20 Main Street
Topsfield, MA 01983
Plummer's Ace Hardware
57 Main Street
Gorham, ME 04038
Maine Hardware
274 St. John Street
Portland, ME 04102
Reading Lumber
110 Main Street
North Reading, MA 01864
Eldredge Lumber
145 Presumpscot St
Portland, ME 04103
E.M. Heath Ace Hardware
318 Whittier Hwy
Center Harbor, NH 03226
Westford Ace Hardware
527 Groton Road
Westford, MA 01886
O'Connor Hardware
446 Boston Rd
Billerica, MA 01821
Marblehead Hardware
70 Atlantic Ave
Marblehead, MA 01945
Moison Ace Hardware
333 Great Road
Bedford, MA 01730
Moison Ace Hardware
143 Main Street
Groton, MA 01450
Rocky's Ace Hardware
(1 Review)
203 Sudbury Rd
Concord, MA 01742
Model ACE Hardware
22 Harvard Ave
Allston, MA 02134
Wayland Home & Design
70 Andrews Ave
Wayland, MA 01778
Rocky's Ace Hardware
55 Congress Ave
Bath, ME 04530
Westborough Ace Hardware
1 Phillips Street
Westborough, MA 01581
Hamshaw Lumber
3 Bradco Street
Keene, NH 03431
Rocky's Ace Hardware
653 Main Street
Walpole, MA 02081
Rocky's Ace Hardware
813 Main Street
Millis, MA 02054
Rocky's Ace Hardware
160 Reservoir St
Holden, MA 01520
Fernandes Lumber & Home Center
(1 Review)
299 Depot Street
South Easton, MA 02375
Milford Ace Hardware
146 S Main Street
Milford, MA 01757
Hamshaw Lumber
68 New Athol Road
Orange, MA 01364
Hamshaw Lumber
99 S Barre Rd
Barre, MA 01005
Aubuchon Ace Hardware
41 Concord Rd
Lee, NH 03861
Aubuchon Ace Hardware
1A N Main Street
Newmarket, NH 03857
Aubuchon Hardware
7 Main Street
Alton, NH 03809
Aubuchon Hardware
114 County Road
Ipswich, MA 01938
Aubuchon Hardware
50 Enon Street
Beverly, MA 01915
County Stores
(1 Review)
321 Nashua Street
Milford, NH 03055
Aubuchon Hardware
838 Lake Street
Bristol, NH 03222
Aubuchon Hardware
499 Roosevelt Trail
Naples, ME 04055
The Bar-B-Que Barn
(1 Review)
9 Dudley Street Place
Arlington, MA 02476
Aubuchon Hardware
117 Great Road
Stow, MA 01775
Aubuchon Hardware
505 Boston Post Rd
Sudbury, MA 01776
Curry Ace Hardware
370 Copeland Street
Quincy, MA 02169
Aubuchon Hardware
(1 Review)
828 Chief Justice Cushing Hwy
Cohasset, MA 02025
Curry Ace Hardware
1271 Washington Street
Hanover, MA 02339
Aubuchon Hardware
182 Summer Street
Kingston, MA 02364
Mansfield Ace Hardware
(1 Review)
65 Copeland Dr
Mansfield, MA 02048
Directions
Contact
Website
Product Information
This high quality, stainless steel temperature gauge - with a large, easy-to-read 3 inch dial - precisely monitors the temperatures inside the dome of an EGG, allowing you to achieve and maintain precise cooking temperatures Oversized 3 in (8 cm) Dial Stainless Steel External Temperature Gauge - 117250
- 750F deg / 400C deg
- Works with XXLarge, XLarge, Large, Medium, Small and MiniMax EGGs
- Heavy duty construction, hermetically sealed
- Designed and manufactured in the USA
Installation:
- Carefully insert stem from the outside through small hole in dome of the EGG; the silicone washer should remain on the outside of the EGG.
- Carefully reach inside the dome, and slide retaining clip onto the stem. Squeeze the clip so that it slides easily.
- Slide clip up the stem until the silicone washer -x001F-ts snugly against the exterior of the dome. For accurate reading, thermometer must be installed past the groove on the lower portion of stem as shown below.
This thermometer is calibrated and adjusted at the factory. If you are in high altitudes or wish to check the calibration:
- Bring a clean container of water to a boil.
- Carefully place the end of the thermometer probe into boiling water past the groove on the lower portion of stem. Leave immersed for at least one minute taking care not to let the probe rest on or make contact with the container.
- Boiling point will read 212 deg F/100 deg C at sea level. Boiling point decreases approx 2 deg with each 1000' of altitude. If the thermometer does not read 212 deg F/100 deg C at sea level, calibration can be reset by carefully holding the thermometer head and turning the hex nut with a wrench to move dial in one direction or the other.
- CAUTION - Do not adjust hot thermometer with bare hands!
- CAUTION - Do not hold thermometer with bare hands while placing in boiling water as burns can result!
- CAUTION - Thermometer tip is sharp, do not leave unattended or place within reach of children.
Product Reviews
There are no reviews yet for Big Green Egg: Temperature Gauge, 3 inch Dial .
Write a Review
