Big Green Egg
Temperature Gauge, 3 inch Dial in Cayce, SC
MSRP
Product Information
This high quality, stainless steel temperature gauge - with a large, easy-to-read 3 inch dial - precisely monitors the temperatures inside the dome of an EGG, allowing you to achieve and maintain precise cooking temperatures Oversized 3 in (8 cm) Dial Stainless Steel External Temperature Gauge - 117250
- 750F deg / 400C deg
- Works with XXLarge, XLarge, Large, Medium, Small and MiniMax EGGs
- Heavy duty construction, hermetically sealed
- Designed and manufactured in the USA
Installation:
- Carefully insert stem from the outside through small hole in dome of the EGG; the silicone washer should remain on the outside of the EGG.
- Carefully reach inside the dome, and slide retaining clip onto the stem. Squeeze the clip so that it slides easily.
- Slide clip up the stem until the silicone washer -x001F-ts snugly against the exterior of the dome. For accurate reading, thermometer must be installed past the groove on the lower portion of stem as shown below.
This thermometer is calibrated and adjusted at the factory. If you are in high altitudes or wish to check the calibration:
- Bring a clean container of water to a boil.
- Carefully place the end of the thermometer probe into boiling water past the groove on the lower portion of stem. Leave immersed for at least one minute taking care not to let the probe rest on or make contact with the container.
- Boiling point will read 212 deg F/100 deg C at sea level. Boiling point decreases approx 2 deg with each 1000' of altitude. If the thermometer does not read 212 deg F/100 deg C at sea level, calibration can be reset by carefully holding the thermometer head and turning the hex nut with a wrench to move dial in one direction or the other.
- CAUTION - Do not adjust hot thermometer with bare hands!
- CAUTION - Do not hold thermometer with bare hands while placing in boiling water as burns can result!
- CAUTION - Thermometer tip is sharp, do not leave unattended or place within reach of children.
Select a Store
Selected Store
21 locations / In stock at 21
In stock at 20 other locations
South East Ace, Inc.
815 State St
Cayce, SC 29033
Three Fountains Ace Hardware
2930 Emanuel Church Rd
West Columbia, SC 29170
Jack Oliver's Pool Service
3303 Forest Drive
Columbia, SC 29204
Wateree Ace Hardware
886 Hwy 1 South
Lugoff, SC 29078
Simpson Ace Hardware
(3 Reviews)
40 W Wesmark Blvd
Sumter, SC 29150
Robertson's Ace Hardware - Clinton
107 Jacobs Hwy Suite B
Clinton, SC 29325
Holly Hill Ace
8516 Old States Rd
Holly Hill, SC 29059
Robertson's Ace Hardware
340 Hillcrest Dr.
Laurens, SC 29360
Rock Hill Ace Hardware
725 Cherry Rd
Rock Hill, SC 29732
Waxhaw Ace Hardware
3927 Providence Rd South
Waxhaw, NC 28173
Elder's Ace Hardware-Florence
155 S Cashua Drive
Florence, SC 29501
Westbury Ace Hardware
1050 Bells Hwy
Walterboro, SC 29488
Irwin Ace Hardware
147 Fernwood Dr
Spartanburg, SC 29307
Blackhawk Hardware
4225 Park Road Shopping Center
Charlotte, NC 28209
Aiken Ace Hardware
1650 Richland Ave W
Aiken, SC 29801
New Ellenton Ace Hardware
605 Main Street
New Ellenton, SC 29809
Carrol Ace Hardware of Fort Mill
1785 Gold Hill Rd
Fort Mill, SC 29708
Summit Ace of Abbeville
(1 Review)
809 W Greenwood St
Abbeville, SC 29620
Simpson Hardware & Sports
222 North Church St
Lake City, SC 29560
Westlake Ace of Charlotte
15221 John J Delaney Dr
Charlotte, NC 28277
Salter Building Supply
287 Old Millen Hwy
Waynesboro, GA 30830
Directions
Contact
Website
Product Information
This high quality, stainless steel temperature gauge - with a large, easy-to-read 3 inch dial - precisely monitors the temperatures inside the dome of an EGG, allowing you to achieve and maintain precise cooking temperatures Oversized 3 in (8 cm) Dial Stainless Steel External Temperature Gauge - 117250
- 750F deg / 400C deg
- Works with XXLarge, XLarge, Large, Medium, Small and MiniMax EGGs
- Heavy duty construction, hermetically sealed
- Designed and manufactured in the USA
Installation:
- Carefully insert stem from the outside through small hole in dome of the EGG; the silicone washer should remain on the outside of the EGG.
- Carefully reach inside the dome, and slide retaining clip onto the stem. Squeeze the clip so that it slides easily.
- Slide clip up the stem until the silicone washer -x001F-ts snugly against the exterior of the dome. For accurate reading, thermometer must be installed past the groove on the lower portion of stem as shown below.
This thermometer is calibrated and adjusted at the factory. If you are in high altitudes or wish to check the calibration:
- Bring a clean container of water to a boil.
- Carefully place the end of the thermometer probe into boiling water past the groove on the lower portion of stem. Leave immersed for at least one minute taking care not to let the probe rest on or make contact with the container.
- Boiling point will read 212 deg F/100 deg C at sea level. Boiling point decreases approx 2 deg with each 1000' of altitude. If the thermometer does not read 212 deg F/100 deg C at sea level, calibration can be reset by carefully holding the thermometer head and turning the hex nut with a wrench to move dial in one direction or the other.
- CAUTION - Do not adjust hot thermometer with bare hands!
- CAUTION - Do not hold thermometer with bare hands while placing in boiling water as burns can result!
- CAUTION - Thermometer tip is sharp, do not leave unattended or place within reach of children.
Product Reviews
There are no reviews yet for Big Green Egg: Temperature Gauge, 3 inch Dial .
Write a Review
