Skip to main content
Search
Big Green Egg

Temperature Gauge, 3 inch Dial in Brainerd, MN 56401

$29.99 USD
MSRP
Big Green Egg - Temperature Gauge, 3 inch Dial in Brainerd Mn 56401

Product Information

This high quality, stainless steel temperature gauge - with a large, easy-to-read 3 inch dial - precisely monitors the temperatures inside the dome of an EGG, allowing you to achieve and maintain precise cooking temperatures Oversized 3 in (8 cm) Dial Stainless Steel External Temperature Gauge - 117250

  • 750F deg / 400C deg
  • Works with XXLarge, XLarge, Large, Medium, Small and MiniMax EGGs
  • Heavy duty construction, hermetically sealed
  • Designed and manufactured in the USA

Installation:

  1. Carefully insert stem from the outside through small hole in dome of the EGG; the silicone washer should remain on the outside of the EGG.
  2. Carefully reach inside the dome, and slide retaining clip onto the stem. Squeeze the clip so that it slides easily.
  3. Slide clip up the stem until the silicone washer -x001F-ts snugly against the exterior of the dome. For accurate reading, thermometer must be installed past the groove on the lower portion of stem as shown below.

This thermometer is calibrated and adjusted at the factory. If you are in high altitudes or wish to check the calibration:

  1. Bring a clean container of water to a boil.
  2. Carefully place the end of the thermometer probe into boiling water past the groove on the lower portion of stem. Leave immersed for at least one minute taking care not to let the probe rest on or make contact with the container.
  3. Boiling point will read 212 deg F/100 deg C at sea level. Boiling point decreases approx 2 deg with each 1000' of altitude. If the thermometer does not read 212 deg F/100 deg C at sea level, calibration can be reset by carefully holding the thermometer head and turning the hex nut with a wrench to move dial in one direction or the other.
  • CAUTION - Do not adjust hot thermometer with bare hands!
  • CAUTION - Do not hold thermometer with bare hands while placing in boiling water as burns can result!
  • CAUTION - Thermometer tip is sharp, do not leave unattended or place within reach of children.

This item is in stock locally
Change Store

Select a Store

Selected Store

10 locations / In stock at 10

In stock at 9 other locations

In Stock

as of 1 hour ago

Ace Hardware - Brainerd

214 West Washington St
Brainerd, MN 56401

0.7 mi

Pickup Available Now

Ace Hardware - Brainerd

In Stock

as of 1 hour ago

Nisswa Hardware

25673 Main Street
Nisswa, MN 56468

12.5 mi

Pickup Available Now

In Stock

as of 1 hour ago

Ace Hardware

1101 2nd Ave
Little Falls, MN 56345

26.8 mi

Pickup Available Now

In Stock

as of 3 hours ago

Scheels - St Cloud

30 Waite Ave N
St Cloud, MN 56301

55.0 mi
Open

Pickup Available Now

Scheels - St Cloud

In Stock

as of 1 hour ago

Cwikla Ace Hardware

802 1st Street E
Park Rapids, MN 56470

56.1 mi

Pickup Available Now

In Stock

as of 1 hour ago

Burggraf's Ace Hardware

1115 Highway 169 East
Grand Rapids, MN 55744

69.3 mi

Pickup Available Now

In Stock

as of 1 hour ago

Ace Hardware of Albertville

6050 Labeaux Ave NE
Albertville, MN 55301

81.2 mi

Pickup Available Now

In Stock

as of 1 hour ago

Ace on the Lake

600 Paul Bunyan Drive
Bemidji, MN 56601

83.0 mi

Pickup Available Now

In Stock

as of 1 hour ago

Ace Hardware

15700 88th St NE
Otsego, MN 55330

80.2 mi
Ace Hardware

In Stock

as of 18 hours ago

Lakeland Dock & Lift

29000 US-10
Detroit Lakes, MN 56501

81.2 mi
Open
Lakeland Dock & Lift

Product Information

This high quality, stainless steel temperature gauge - with a large, easy-to-read 3 inch dial - precisely monitors the temperatures inside the dome of an EGG, allowing you to achieve and maintain precise cooking temperatures Oversized 3 in (8 cm) Dial Stainless Steel External Temperature Gauge - 117250

  • 750F deg / 400C deg
  • Works with XXLarge, XLarge, Large, Medium, Small and MiniMax EGGs
  • Heavy duty construction, hermetically sealed
  • Designed and manufactured in the USA

Installation:

  1. Carefully insert stem from the outside through small hole in dome of the EGG; the silicone washer should remain on the outside of the EGG.
  2. Carefully reach inside the dome, and slide retaining clip onto the stem. Squeeze the clip so that it slides easily.
  3. Slide clip up the stem until the silicone washer -x001F-ts snugly against the exterior of the dome. For accurate reading, thermometer must be installed past the groove on the lower portion of stem as shown below.

This thermometer is calibrated and adjusted at the factory. If you are in high altitudes or wish to check the calibration:

  1. Bring a clean container of water to a boil.
  2. Carefully place the end of the thermometer probe into boiling water past the groove on the lower portion of stem. Leave immersed for at least one minute taking care not to let the probe rest on or make contact with the container.
  3. Boiling point will read 212 deg F/100 deg C at sea level. Boiling point decreases approx 2 deg with each 1000' of altitude. If the thermometer does not read 212 deg F/100 deg C at sea level, calibration can be reset by carefully holding the thermometer head and turning the hex nut with a wrench to move dial in one direction or the other.
  • CAUTION - Do not adjust hot thermometer with bare hands!
  • CAUTION - Do not hold thermometer with bare hands while placing in boiling water as burns can result!
  • CAUTION - Thermometer tip is sharp, do not leave unattended or place within reach of children.

Product Reviews

There are no reviews yet for Big Green Egg: Temperature Gauge, 3 inch Dial .

Write a Review