Big Green Egg
Temperature Gauge, 3 inch Dial in Alpine County, CA
MSRP
Product Information
This high quality, stainless steel temperature gauge - with a large, easy-to-read 3 inch dial - precisely monitors the temperatures inside the dome of an EGG, allowing you to achieve and maintain precise cooking temperatures Oversized 3 in (8 cm) Dial Stainless Steel External Temperature Gauge - 117250
- 750F deg / 400C deg
- Works with XXLarge, XLarge, Large, Medium, Small and MiniMax EGGs
- Heavy duty construction, hermetically sealed
- Designed and manufactured in the USA
Installation:
- Carefully insert stem from the outside through small hole in dome of the EGG; the silicone washer should remain on the outside of the EGG.
- Carefully reach inside the dome, and slide retaining clip onto the stem. Squeeze the clip so that it slides easily.
- Slide clip up the stem until the silicone washer -x001F-ts snugly against the exterior of the dome. For accurate reading, thermometer must be installed past the groove on the lower portion of stem as shown below.
This thermometer is calibrated and adjusted at the factory. If you are in high altitudes or wish to check the calibration:
- Bring a clean container of water to a boil.
- Carefully place the end of the thermometer probe into boiling water past the groove on the lower portion of stem. Leave immersed for at least one minute taking care not to let the probe rest on or make contact with the container.
- Boiling point will read 212 deg F/100 deg C at sea level. Boiling point decreases approx 2 deg with each 1000' of altitude. If the thermometer does not read 212 deg F/100 deg C at sea level, calibration can be reset by carefully holding the thermometer head and turning the hex nut with a wrench to move dial in one direction or the other.
- CAUTION - Do not adjust hot thermometer with bare hands!
- CAUTION - Do not hold thermometer with bare hands while placing in boiling water as burns can result!
- CAUTION - Thermometer tip is sharp, do not leave unattended or place within reach of children.
Select a Store
Selected Store
17 locations / In stock at 17
In stock at 16 other locations
Louie's Home Center
(1 Review)
3 Flowery Ave
Dayton, NV 89403
Sender's Market Ace Hardware
72 S Hwy 26
Valley Springs, CA 95252
Hills Flat Lumber - Colfax
1000 South Canyon Way
Colfax, CA 95713
Granite Bay Ace Hardware
8665 Auburn Folsom Rd.
Granite Bay, CA 95746
Wingfield Ace Hardware
2464 Wingfield Hills Rd
Sparks, NV 89436
American River Ace Hardware
9500 Greenback Lane
Folsom, CA 95630
Roseville Ace Hardware
(1 Review)
108A Harding Blvd
Roseville, CA 95678
Hills Flat Lumber - Grass Valley
380 Railroad Ave
Grass Valley, CA 95945
Young's Lockeford Ace
18960 N Hwy 88
Lockeford, CA 95237
Strand Ace Hardware
3360 McHenry Ave.
Escalon, CA 95320
Young's Lodi Ace
211 N Ham Lane
Lodi, CA 95242
Louie's Ace Hardware
1855 West Williams Ave.
Fallon, NV 89406
Elk Grove Ace Hardware
9680 Bruceville Rd
Elk Grove, CA 95757
East Sacramento Ace Hardware
5030 Folsom Blvd
Sacramento, CA 95819
South Meadows Ace Hardware
770 South Meadows Pkwy
Reno, NV 89521
Mira Loma Ace Hardware
3334 S McCarran Blvd
Reno, NV 89502
Miller's Ace Hardware
8077 Madison Ave
Citrus Heights, CA 95610
Directions
Contact
Website
Product Information
This high quality, stainless steel temperature gauge - with a large, easy-to-read 3 inch dial - precisely monitors the temperatures inside the dome of an EGG, allowing you to achieve and maintain precise cooking temperatures Oversized 3 in (8 cm) Dial Stainless Steel External Temperature Gauge - 117250
- 750F deg / 400C deg
- Works with XXLarge, XLarge, Large, Medium, Small and MiniMax EGGs
- Heavy duty construction, hermetically sealed
- Designed and manufactured in the USA
Installation:
- Carefully insert stem from the outside through small hole in dome of the EGG; the silicone washer should remain on the outside of the EGG.
- Carefully reach inside the dome, and slide retaining clip onto the stem. Squeeze the clip so that it slides easily.
- Slide clip up the stem until the silicone washer -x001F-ts snugly against the exterior of the dome. For accurate reading, thermometer must be installed past the groove on the lower portion of stem as shown below.
This thermometer is calibrated and adjusted at the factory. If you are in high altitudes or wish to check the calibration:
- Bring a clean container of water to a boil.
- Carefully place the end of the thermometer probe into boiling water past the groove on the lower portion of stem. Leave immersed for at least one minute taking care not to let the probe rest on or make contact with the container.
- Boiling point will read 212 deg F/100 deg C at sea level. Boiling point decreases approx 2 deg with each 1000' of altitude. If the thermometer does not read 212 deg F/100 deg C at sea level, calibration can be reset by carefully holding the thermometer head and turning the hex nut with a wrench to move dial in one direction or the other.
- CAUTION - Do not adjust hot thermometer with bare hands!
- CAUTION - Do not hold thermometer with bare hands while placing in boiling water as burns can result!
- CAUTION - Thermometer tip is sharp, do not leave unattended or place within reach of children.
Product Reviews
There are no reviews yet for Big Green Egg: Temperature Gauge, 3 inch Dial .
Write a Review
