Big Green Egg
Temperature Gauge, 3 inch Dial
MSRP
Product Information
This high quality, stainless steel temperature gauge - with a large, easy-to-read 3 inch dial - precisely monitors the temperatures inside the dome of an EGG, allowing you to achieve and maintain precise cooking temperatures Oversized 3 in (8 cm) Dial Stainless Steel External Temperature Gauge - 117250
- 750F deg / 400C deg
- Works with XXLarge, XLarge, Large, Medium, Small and MiniMax EGGs
- Heavy duty construction, hermetically sealed
- Designed and manufactured in the USA
Installation:
- Carefully insert stem from the outside through small hole in dome of the EGG; the silicone washer should remain on the outside of the EGG.
- Carefully reach inside the dome, and slide retaining clip onto the stem. Squeeze the clip so that it slides easily.
- Slide clip up the stem until the silicone washer -x001F-ts snugly against the exterior of the dome. For accurate reading, thermometer must be installed past the groove on the lower portion of stem as shown below.
This thermometer is calibrated and adjusted at the factory. If you are in high altitudes or wish to check the calibration:
- Bring a clean container of water to a boil.
- Carefully place the end of the thermometer probe into boiling water past the groove on the lower portion of stem. Leave immersed for at least one minute taking care not to let the probe rest on or make contact with the container.
- Boiling point will read 212 deg F/100 deg C at sea level. Boiling point decreases approx 2 deg with each 1000' of altitude. If the thermometer does not read 212 deg F/100 deg C at sea level, calibration can be reset by carefully holding the thermometer head and turning the hex nut with a wrench to move dial in one direction or the other.
- CAUTION - Do not adjust hot thermometer with bare hands!
- CAUTION - Do not hold thermometer with bare hands while placing in boiling water as burns can result!
- CAUTION - Thermometer tip is sharp, do not leave unattended or place within reach of children.
Select a Store
Selected Store
24 locations / In stock at 24
In stock at 23 other locations
Specialty Gas House
4500 Indianola Ave
Columbus, OH 43214
Schreiner Ace Hardware
926 High St
Worthington, OH 43085
New Albany Ace Hardware
5595 New Albany Rd W
New Albany, OH 43054
Westerville Ace Hardware
1220 County Line Road
Westerville, OH 43081
Johnstown Ace Hardware
921 W Coshocton
Johnstown, OH 43031
Sunbury Ace Hardware
300 W. Granville St.
Sunbury, OH 43074
E&H Ace Hardware
800 W Central Ave
Delaware, OH 43015
Heath Ace Hardware
775 S 30th St
Heath, OH 43056
Handyman Ace Hardware
508 S Burnett Rd
Springfield, OH 45505
Handyman Ace Hardware
122 E Dayton Yellow Springs Road
Fairborn, OH 45324
Wilmington Ace Hardware
1268 Rombach Ave
Wilmington, OH 45177
Handyman Ace Hardware
3300 S Dayton Lakeview Rd
New Carlisle, OH 45344
E&H Hardware
1412 Lexington Ave
Mansfield, OH 44907
Handyman Ace Hardware
1950 E Stroop Road
Kettering, OH 45429
Handyman Ace Hardware
7845 Clyo Road
Centerville, OH 45459
Athens Ace Hardware
470 Richland Ave
Athens, OH 45701
E&H Ace Hardware
714 N. Main Street
Springboro, OH 45066
Lebanon Ace Hardware
729 East Main Street
Lebanon, OH 45036
Shawnee Ace Hardware
3700 S Dixie Hwy
Lima, OH 45806
Ace Hardware Loveland
675 Loveland Madeira Rd
Loveland, OH 45140
Rocky's Handyman Ace
251 E Alex Bell Rd
Centerville, OH 45459
Farm & Home Hardware
140 Center Street
Ashland, OH 44805
Versailles Ace Hardware
337 Marker Rd
Versailles, OH 45380
Village Hardware
10320 US 224
Findlay, OH 45840
Product Information
This high quality, stainless steel temperature gauge - with a large, easy-to-read 3 inch dial - precisely monitors the temperatures inside the dome of an EGG, allowing you to achieve and maintain precise cooking temperatures Oversized 3 in (8 cm) Dial Stainless Steel External Temperature Gauge - 117250
- 750F deg / 400C deg
- Works with XXLarge, XLarge, Large, Medium, Small and MiniMax EGGs
- Heavy duty construction, hermetically sealed
- Designed and manufactured in the USA
Installation:
- Carefully insert stem from the outside through small hole in dome of the EGG; the silicone washer should remain on the outside of the EGG.
- Carefully reach inside the dome, and slide retaining clip onto the stem. Squeeze the clip so that it slides easily.
- Slide clip up the stem until the silicone washer -x001F-ts snugly against the exterior of the dome. For accurate reading, thermometer must be installed past the groove on the lower portion of stem as shown below.
This thermometer is calibrated and adjusted at the factory. If you are in high altitudes or wish to check the calibration:
- Bring a clean container of water to a boil.
- Carefully place the end of the thermometer probe into boiling water past the groove on the lower portion of stem. Leave immersed for at least one minute taking care not to let the probe rest on or make contact with the container.
- Boiling point will read 212 deg F/100 deg C at sea level. Boiling point decreases approx 2 deg with each 1000' of altitude. If the thermometer does not read 212 deg F/100 deg C at sea level, calibration can be reset by carefully holding the thermometer head and turning the hex nut with a wrench to move dial in one direction or the other.
- CAUTION - Do not adjust hot thermometer with bare hands!
- CAUTION - Do not hold thermometer with bare hands while placing in boiling water as burns can result!
- CAUTION - Thermometer tip is sharp, do not leave unattended or place within reach of children.
Product Reviews
There are no reviews yet for Big Green Egg: Temperature Gauge, 3 inch Dial .
Write a Review