Big Green Egg
Temperature Gauge, 2 inch Dial in Springfield, TN 37172
MSRP
Product Information
This high quality, stainless steel temperature gauge - with an easy-to-read dial - precisely monitors the temperatures inside the dome of an EGG, allowing you to achieve and maintain precise cooking temperatures 2 in Dial Stainless Steel External Temperature Gauge - 117236
- 750F deg / 400C deg
- Works with XXLarge, XLarge, Large, Medium, Small and MiniMax EGGs
- Heavy duty construction, hermetically sealed
- Designed and manufactured in the USA
Installation:
- Carefully insert stem from the outside through small hole in dome of the EGG; the silicone washer should remain on the outside of the EGG.
- Carefully reach inside the dome, and slide retaining clip onto the stem. Squeeze the clip so that it slides easily.
- Slide clip up the stem until the silicone washer -x001F-ts snugly against the exterior of the dome. For accurate reading, thermometer must be installed past the groove on the lower portion of stem as shown below.
This thermometer is calibrated and adjusted at the factory. If you are in high altitudes or wish to check the calibration:
- Bring a clean container of water to a boil.
- Carefully place the end of the thermometer probe into boiling water past the groove on the lower portion of stem. Leave immersed for at least one minute taking care not to let the probe rest on or make contact with the container.
- Boiling point will read 212 deg F/100 deg C at sea level. Boiling point decreases approx 2 deg with each 1000' of altitude. If the thermometer does not read 212 deg F/100 deg C at sea level, calibration can be reset by carefully holding the thermometer head and turning the hex nut with a wrench to move dial in one direction or the other.
- CAUTION - Do not adjust hot thermometer with bare hands!
- CAUTION - Do not hold thermometer with bare hands while placing in boiling water as burns can result!
- CAUTION - Thermometer tip is sharp, do not leave unattended or place within reach of children.
Select a Store
Selected Store
20 locations / In stock at 20
In stock at 19 other locations
Ace Hardware Springfield
400 Central Ave E
Springfield, TN 37172
Ace Hardware Marketplace Franklin
710 El Cedar Street
Franklin, KY 42134
Elder's Ace Hardware of East Nashville
2622 Gallatin Pike
Nashville, TN 37216
Ace Hardware Donelson
2730 Lebanon Pike
Nashville, TN 37214
Ace Hardware Marketplace
2706 Russellville Rd
Bowling Green, KY 42101
Ace Hardware
1435 New Gallatin Road
Scottsville, KY 42164
Ace Hardware Marketplace
709 US 31 West Bypass
Bowling Green, KY 42101
Ace Hardware
507 West G L Smith Street
Morgantown, KY 42261
Tripp's Ace Hardware
112 E James Campbell Blvd
Columbia, TN 38401
Cave City Ace Hardware
9586 Happy Valley Rd
Cave City, KY 42127
Tompkinsville Ace Hardware
702 N Main Street
Tompkinsville, KY 42167
Potters Ace Hardware
6419 Nashville Hwy
Baxter, TN 38544
Akridge Farm Supply
724 W Fairview Avenue
Eddyville, KY 42038
Potters Ace Hardware
325 Newman Dr
Cookeville, TN 38501
Potters Ace Hardware
615 W Main Street
Algood, TN 38506
615 Outdoor Living
9857 Lebanon Rd
Mt. Juliet, TN 37122
B & C Hardware
124 Pewitt Dr
Brentwood, TN 37027
Elder's Ace Hardware of Smyrna
(1 Review)
415 Nissan Dr
Smyrna, TN 37167
Lafayette Ace Hardware
411 Highway 52 Bypass East
Lafayette, TN 37083
Elder's Ace Hardware of Murfreesboro
1807 Memorial Blvd
Murfreesboro, TN 37129
Directions
Contact
Website
Product Information
This high quality, stainless steel temperature gauge - with an easy-to-read dial - precisely monitors the temperatures inside the dome of an EGG, allowing you to achieve and maintain precise cooking temperatures 2 in Dial Stainless Steel External Temperature Gauge - 117236
- 750F deg / 400C deg
- Works with XXLarge, XLarge, Large, Medium, Small and MiniMax EGGs
- Heavy duty construction, hermetically sealed
- Designed and manufactured in the USA
Installation:
- Carefully insert stem from the outside through small hole in dome of the EGG; the silicone washer should remain on the outside of the EGG.
- Carefully reach inside the dome, and slide retaining clip onto the stem. Squeeze the clip so that it slides easily.
- Slide clip up the stem until the silicone washer -x001F-ts snugly against the exterior of the dome. For accurate reading, thermometer must be installed past the groove on the lower portion of stem as shown below.
This thermometer is calibrated and adjusted at the factory. If you are in high altitudes or wish to check the calibration:
- Bring a clean container of water to a boil.
- Carefully place the end of the thermometer probe into boiling water past the groove on the lower portion of stem. Leave immersed for at least one minute taking care not to let the probe rest on or make contact with the container.
- Boiling point will read 212 deg F/100 deg C at sea level. Boiling point decreases approx 2 deg with each 1000' of altitude. If the thermometer does not read 212 deg F/100 deg C at sea level, calibration can be reset by carefully holding the thermometer head and turning the hex nut with a wrench to move dial in one direction or the other.
- CAUTION - Do not adjust hot thermometer with bare hands!
- CAUTION - Do not hold thermometer with bare hands while placing in boiling water as burns can result!
- CAUTION - Thermometer tip is sharp, do not leave unattended or place within reach of children.
Product Reviews
There are no reviews yet for Big Green Egg: Temperature Gauge, 2 inch Dial .
Write a Review
