Big Green Egg
Temperature Gauge, 2 inch Dial in Slingerlands, NY 12159
MSRP
Product Information
This high quality, stainless steel temperature gauge - with an easy-to-read dial - precisely monitors the temperatures inside the dome of an EGG, allowing you to achieve and maintain precise cooking temperatures 2 in Dial Stainless Steel External Temperature Gauge - 117236
- 750F deg / 400C deg
- Works with XXLarge, XLarge, Large, Medium, Small and MiniMax EGGs
- Heavy duty construction, hermetically sealed
- Designed and manufactured in the USA
Installation:
- Carefully insert stem from the outside through small hole in dome of the EGG; the silicone washer should remain on the outside of the EGG.
- Carefully reach inside the dome, and slide retaining clip onto the stem. Squeeze the clip so that it slides easily.
- Slide clip up the stem until the silicone washer -x001F-ts snugly against the exterior of the dome. For accurate reading, thermometer must be installed past the groove on the lower portion of stem as shown below.
This thermometer is calibrated and adjusted at the factory. If you are in high altitudes or wish to check the calibration:
- Bring a clean container of water to a boil.
- Carefully place the end of the thermometer probe into boiling water past the groove on the lower portion of stem. Leave immersed for at least one minute taking care not to let the probe rest on or make contact with the container.
- Boiling point will read 212 deg F/100 deg C at sea level. Boiling point decreases approx 2 deg with each 1000' of altitude. If the thermometer does not read 212 deg F/100 deg C at sea level, calibration can be reset by carefully holding the thermometer head and turning the hex nut with a wrench to move dial in one direction or the other.
- CAUTION - Do not adjust hot thermometer with bare hands!
- CAUTION - Do not hold thermometer with bare hands while placing in boiling water as burns can result!
- CAUTION - Thermometer tip is sharp, do not leave unattended or place within reach of children.
Select a Store
Selected Store
28 locations / In stock at 28
In stock at 27 other locations
Robinson Hardware & Garden Center
1900 New Scotland Road
Slingerlands, NY 12159
Robinson Ace Hardware
1874 Western Ave
Albany, NY 12203
Hatchet Hardware of Colonie
1 Fuller Road
Colonie, NY 12205
Hatchet Hardware of Niskayuna
1448 Balltown Rd
Niskayuna, NY 12309
Hatchet Hardware of Waterford
42 Saratoga Ave
Waterford, NY 12188
Hatchet Hardware of Brunswick
831 Hoosick Road
Troy, NY 12180
Allerdice Ace Hardware
2570 State Hwy 9
Malta, NY 12020
John's Ace Hardware
850 Crane Ave
Pittsfield, MA 01201
Noble Ace Hardware
130 South Comrie Ave
Johnstown, NY 12095
St. Andrews Ace Hardware
827 State Route 9
Queensbury, NY 12804
Rocky's Ace Hardware
10 Springfield S
Agawam, MA 01001
Larsen Ace Hardware
220 Albany Turnpike
Canton, CT 06019
Rocky's Ace Hardware
28 North Main Street
East Long Meadow, MA 01028
Bibens Ace Hardware
362 River Street
North Springfield, VT 05150
Hamshaw Lumber
68 New Athol Road
Orange, MA 01364
Larsen Ace Hardware
982 Farmington Avenue
West Hartford, CT 06107
Persico Ace Hardware
99 Main Street
Ravena, NY 12143
Carr Hardware
547 North Street
Pittsfield, MA 01201
Carr Hardware
489 Pittsfield Road
Lenox, MA 01240
Aubuchon Hardware
511 State RT 29
Greenwich, NY 12834
Aubuchon Ace Hardware
40 E Main Street
Cambridge, NY 12816
Aubuchon Hardware
129 Main Street
Richfield Springs, NY 13439
Aubuchon Hardware
312 Federal Street
Greenfield, MA 01301
Ace Hardware of Litchfield
348 Bantam Rd
Litchfield, CT 06759
Rocky's Ace Hardware
1381 Liberty Street
Springfield, MA 01104
Carr Hardware
320 W Main Street
Avon, CT 06001
Aubuchon Hardware
261 N Main Street
Rutland, VT 05701
Aubuchon Hardware
690 Main Sreet S
Woodbury, CT 06798
Product Information
This high quality, stainless steel temperature gauge - with an easy-to-read dial - precisely monitors the temperatures inside the dome of an EGG, allowing you to achieve and maintain precise cooking temperatures 2 in Dial Stainless Steel External Temperature Gauge - 117236
- 750F deg / 400C deg
- Works with XXLarge, XLarge, Large, Medium, Small and MiniMax EGGs
- Heavy duty construction, hermetically sealed
- Designed and manufactured in the USA
Installation:
- Carefully insert stem from the outside through small hole in dome of the EGG; the silicone washer should remain on the outside of the EGG.
- Carefully reach inside the dome, and slide retaining clip onto the stem. Squeeze the clip so that it slides easily.
- Slide clip up the stem until the silicone washer -x001F-ts snugly against the exterior of the dome. For accurate reading, thermometer must be installed past the groove on the lower portion of stem as shown below.
This thermometer is calibrated and adjusted at the factory. If you are in high altitudes or wish to check the calibration:
- Bring a clean container of water to a boil.
- Carefully place the end of the thermometer probe into boiling water past the groove on the lower portion of stem. Leave immersed for at least one minute taking care not to let the probe rest on or make contact with the container.
- Boiling point will read 212 deg F/100 deg C at sea level. Boiling point decreases approx 2 deg with each 1000' of altitude. If the thermometer does not read 212 deg F/100 deg C at sea level, calibration can be reset by carefully holding the thermometer head and turning the hex nut with a wrench to move dial in one direction or the other.
- CAUTION - Do not adjust hot thermometer with bare hands!
- CAUTION - Do not hold thermometer with bare hands while placing in boiling water as burns can result!
- CAUTION - Thermometer tip is sharp, do not leave unattended or place within reach of children.
Product Reviews
There are no reviews yet for Big Green Egg: Temperature Gauge, 2 inch Dial .
Write a Review