Big Green Egg
Temperature Gauge, 2 inch Dial in Seattle, WA
MSRP
Product Information
This high quality, stainless steel temperature gauge - with an easy-to-read dial - precisely monitors the temperatures inside the dome of an EGG, allowing you to achieve and maintain precise cooking temperatures 2 in Dial Stainless Steel External Temperature Gauge - 117236
- 750F deg / 400C deg
- Works with XXLarge, XLarge, Large, Medium, Small and MiniMax EGGs
- Heavy duty construction, hermetically sealed
- Designed and manufactured in the USA
Installation:
- Carefully insert stem from the outside through small hole in dome of the EGG; the silicone washer should remain on the outside of the EGG.
- Carefully reach inside the dome, and slide retaining clip onto the stem. Squeeze the clip so that it slides easily.
- Slide clip up the stem until the silicone washer -x001F-ts snugly against the exterior of the dome. For accurate reading, thermometer must be installed past the groove on the lower portion of stem as shown below.
This thermometer is calibrated and adjusted at the factory. If you are in high altitudes or wish to check the calibration:
- Bring a clean container of water to a boil.
- Carefully place the end of the thermometer probe into boiling water past the groove on the lower portion of stem. Leave immersed for at least one minute taking care not to let the probe rest on or make contact with the container.
- Boiling point will read 212 deg F/100 deg C at sea level. Boiling point decreases approx 2 deg with each 1000' of altitude. If the thermometer does not read 212 deg F/100 deg C at sea level, calibration can be reset by carefully holding the thermometer head and turning the hex nut with a wrench to move dial in one direction or the other.
- CAUTION - Do not adjust hot thermometer with bare hands!
- CAUTION - Do not hold thermometer with bare hands while placing in boiling water as burns can result!
- CAUTION - Thermometer tip is sharp, do not leave unattended or place within reach of children.
Select a Store
Selected Store
27 locations / In stock at 27
In stock at 26 other locations
Bainbridge Island Ace Hardware
635 High School Road NE
Bainbridge Island, WA 98110
Westlake Ace Hardware
6613 132nd Ave NE
Kirkland, WA 98033
Highlands Ace Hardware
4601 NE Sunset Blvd
Renton, WA 98059
Edmonds Bowl Ace Hardware
550 5th Ave. S
Edmonds, WA 98020
Scott McLendon's Ace
1692 SE Mile Hill Dr
Port Orchard, WA 98366
Ace Hardware
3506 Kitsap Way
Bremerton, WA 98312
Scott McLendon's Ace
51 NE State Route 300
Belfair, WA 98528
North Bend Ace Hardware
330 Main Ave S
North Bend, WA 98045
Lake Stevens Ace Hardware
303 91st Ave NE
Lake Stevens, WA 98258
Camano Plaza Ace Hardware
370 NE Camano Dr
Camano Island, WA 98282
Oak Harbor Ace Hardware
150 SE Pioneer
Oak Harbor, WA 98277
Lincoln Creek Lumber
2421 93rd Ave SW
Turnwater, WA 98512
Lincoln Creek Lumber Ace Hardware
1621 Harrison Ave
Centralia, WA 98531
Market Street Ace Hardware
771 S. Market St.
Chehalis, WA 98532
Junction Ace Hardware
4747 44th Ave SW
Seattle, WA 98116
Sutter Home & Hearth
920 Leary Way NW
Seattle, WA 98107
Westlake Ace Hardware
17171 Bothell Way NE
Lake Forest Park, WA 98155
Sammamish Ace Hardware
22650 SE 4th St #200
Sammamish, WA 98074
Fairwood Ace Hardware
14100 SE Petrovitsky Rd
Renton, WA 98058
Thompson's Hearth & Home
680 Northwest Gilman Blvd
Issaquah, WA 98027
Lynnwood Ace Hardware
19719 Hwy 99
Lynnwood, WA 98036
McDaniel's Do It Center
510 2nd St
Snohomish, WA 98290
Milton Ace Hardware
2800 Milton Way
Milton, WA 98354
Ace Freeland Home Center
1609 Main Street
Freeland, WA 98249
Ag Supply Co Ace Hardware
13410 Meridian Ave E
Puyallup, WA 98373
Hawk's Prairie Ace Hardware
1401 Marvin Rd NE
Lacey, WA 98516
Sequim Ace Hardware
232 Valley Central Place
Sequim, WA 98382
Product Information
This high quality, stainless steel temperature gauge - with an easy-to-read dial - precisely monitors the temperatures inside the dome of an EGG, allowing you to achieve and maintain precise cooking temperatures 2 in Dial Stainless Steel External Temperature Gauge - 117236
- 750F deg / 400C deg
- Works with XXLarge, XLarge, Large, Medium, Small and MiniMax EGGs
- Heavy duty construction, hermetically sealed
- Designed and manufactured in the USA
Installation:
- Carefully insert stem from the outside through small hole in dome of the EGG; the silicone washer should remain on the outside of the EGG.
- Carefully reach inside the dome, and slide retaining clip onto the stem. Squeeze the clip so that it slides easily.
- Slide clip up the stem until the silicone washer -x001F-ts snugly against the exterior of the dome. For accurate reading, thermometer must be installed past the groove on the lower portion of stem as shown below.
This thermometer is calibrated and adjusted at the factory. If you are in high altitudes or wish to check the calibration:
- Bring a clean container of water to a boil.
- Carefully place the end of the thermometer probe into boiling water past the groove on the lower portion of stem. Leave immersed for at least one minute taking care not to let the probe rest on or make contact with the container.
- Boiling point will read 212 deg F/100 deg C at sea level. Boiling point decreases approx 2 deg with each 1000' of altitude. If the thermometer does not read 212 deg F/100 deg C at sea level, calibration can be reset by carefully holding the thermometer head and turning the hex nut with a wrench to move dial in one direction or the other.
- CAUTION - Do not adjust hot thermometer with bare hands!
- CAUTION - Do not hold thermometer with bare hands while placing in boiling water as burns can result!
- CAUTION - Thermometer tip is sharp, do not leave unattended or place within reach of children.
Product Reviews
There are no reviews yet for Big Green Egg: Temperature Gauge, 2 inch Dial .
Write a Review