Big Green Egg
Temperature Gauge, 2 inch Dial in Ridgeway, VA 24148
MSRP
Product Information
This high quality, stainless steel temperature gauge - with an easy-to-read dial - precisely monitors the temperatures inside the dome of an EGG, allowing you to achieve and maintain precise cooking temperatures 2 in Dial Stainless Steel External Temperature Gauge - 117236
- 750F deg / 400C deg
- Works with XXLarge, XLarge, Large, Medium, Small and MiniMax EGGs
- Heavy duty construction, hermetically sealed
- Designed and manufactured in the USA
Installation:
- Carefully insert stem from the outside through small hole in dome of the EGG; the silicone washer should remain on the outside of the EGG.
- Carefully reach inside the dome, and slide retaining clip onto the stem. Squeeze the clip so that it slides easily.
- Slide clip up the stem until the silicone washer -x001F-ts snugly against the exterior of the dome. For accurate reading, thermometer must be installed past the groove on the lower portion of stem as shown below.
This thermometer is calibrated and adjusted at the factory. If you are in high altitudes or wish to check the calibration:
- Bring a clean container of water to a boil.
- Carefully place the end of the thermometer probe into boiling water past the groove on the lower portion of stem. Leave immersed for at least one minute taking care not to let the probe rest on or make contact with the container.
- Boiling point will read 212 deg F/100 deg C at sea level. Boiling point decreases approx 2 deg with each 1000' of altitude. If the thermometer does not read 212 deg F/100 deg C at sea level, calibration can be reset by carefully holding the thermometer head and turning the hex nut with a wrench to move dial in one direction or the other.
- CAUTION - Do not adjust hot thermometer with bare hands!
- CAUTION - Do not hold thermometer with bare hands while placing in boiling water as burns can result!
- CAUTION - Thermometer tip is sharp, do not leave unattended or place within reach of children.
Select a Store
Selected Store
22 locations / In stock at 22
In stock at 21 other locations
Northwest Ace Hardware
1188 Mica Road
Ridgeway, VA 24148
Stoney Creek Ace Hardware
941 Center Crest Dr
Whitsett, NC 27377
Northwest Ace Hardware - Winston Salem
3450 Robinhood Road
Winston Salem, NC 27106
Moneta Farm & Home Center
11739 Moneta Rd.
Moneta, VA 24121
Northwest Ace Hardware
3647 Brambleton Ave SW
Roanoke, VA 24018
Northwest Ace Hardware
520 Roanoke St.
Christiansburg, VA 24073
Northwest Ace Hardware
2113 E Washington Ave
Vinton, VA 24179
Northwest Ace Hardware
2913 W Main St
Salem, VA 24153
Steelman's Ace Hardware
5431 US Hwy 158
Advance, NC 27006
Northwest Ace Hardware-Hollins
7650 Williamson Road
Roanoke, VA 24019
Northwest Hardware Company
801 Kabrich St
Blacksburg, VA 24060
Lanier's Ace Hardware
218 S Main St
Lexington, NC 27293
Northwest Ace Hardware
4697 Cleburne Blvd
Dublin, VA 24084
Overstreet Ace Hardware
2650 Lakeside Drive
Lynchburg, VA 24501
Westlake Ace Hardware-Chapel Hill
157 Chatham Downs Dr
Chapel Hill, NC 27517
Westlake Ace Hardware - Cary
2976 Kildaire Farm Rd.
Cary, NC 27518
Westlake Ace Hardware #112
10930-101 Raven Ridge Rd
Raleigh, NC 27614
Westlake Ace Hardware #111
6196-100 Falls of Neuse Rd
Raleigh, NC 27609
Northwest Ace of Walkertown
2700 Old Hollow Rd
Walkertown, NC 27051
Westlake Ace Hardware - High Point
1589 Skeet Club Rd
High Point, NC 27265
Westlake Ace-Pinecrest
9101 Leesville Rd
Raleigh, NC 27613
Lake Boone Ace Hardware
2462 Wycliff Rd
Raleigh, NC 27607
Directions
Contact
Website
Product Information
This high quality, stainless steel temperature gauge - with an easy-to-read dial - precisely monitors the temperatures inside the dome of an EGG, allowing you to achieve and maintain precise cooking temperatures 2 in Dial Stainless Steel External Temperature Gauge - 117236
- 750F deg / 400C deg
- Works with XXLarge, XLarge, Large, Medium, Small and MiniMax EGGs
- Heavy duty construction, hermetically sealed
- Designed and manufactured in the USA
Installation:
- Carefully insert stem from the outside through small hole in dome of the EGG; the silicone washer should remain on the outside of the EGG.
- Carefully reach inside the dome, and slide retaining clip onto the stem. Squeeze the clip so that it slides easily.
- Slide clip up the stem until the silicone washer -x001F-ts snugly against the exterior of the dome. For accurate reading, thermometer must be installed past the groove on the lower portion of stem as shown below.
This thermometer is calibrated and adjusted at the factory. If you are in high altitudes or wish to check the calibration:
- Bring a clean container of water to a boil.
- Carefully place the end of the thermometer probe into boiling water past the groove on the lower portion of stem. Leave immersed for at least one minute taking care not to let the probe rest on or make contact with the container.
- Boiling point will read 212 deg F/100 deg C at sea level. Boiling point decreases approx 2 deg with each 1000' of altitude. If the thermometer does not read 212 deg F/100 deg C at sea level, calibration can be reset by carefully holding the thermometer head and turning the hex nut with a wrench to move dial in one direction or the other.
- CAUTION - Do not adjust hot thermometer with bare hands!
- CAUTION - Do not hold thermometer with bare hands while placing in boiling water as burns can result!
- CAUTION - Thermometer tip is sharp, do not leave unattended or place within reach of children.
Product Reviews
There are no reviews yet for Big Green Egg: Temperature Gauge, 2 inch Dial .
Write a Review
