Big Green Egg
Temperature Gauge, 2 inch Dial in Richmond, TX
MSRP
Product Information
This high quality, stainless steel temperature gauge - with an easy-to-read dial - precisely monitors the temperatures inside the dome of an EGG, allowing you to achieve and maintain precise cooking temperatures 2 in Dial Stainless Steel External Temperature Gauge - 117236
- 750F deg / 400C deg
- Works with XXLarge, XLarge, Large, Medium, Small and MiniMax EGGs
- Heavy duty construction, hermetically sealed
- Designed and manufactured in the USA
Installation:
- Carefully insert stem from the outside through small hole in dome of the EGG; the silicone washer should remain on the outside of the EGG.
- Carefully reach inside the dome, and slide retaining clip onto the stem. Squeeze the clip so that it slides easily.
- Slide clip up the stem until the silicone washer -x001F-ts snugly against the exterior of the dome. For accurate reading, thermometer must be installed past the groove on the lower portion of stem as shown below.
This thermometer is calibrated and adjusted at the factory. If you are in high altitudes or wish to check the calibration:
- Bring a clean container of water to a boil.
- Carefully place the end of the thermometer probe into boiling water past the groove on the lower portion of stem. Leave immersed for at least one minute taking care not to let the probe rest on or make contact with the container.
- Boiling point will read 212 deg F/100 deg C at sea level. Boiling point decreases approx 2 deg with each 1000' of altitude. If the thermometer does not read 212 deg F/100 deg C at sea level, calibration can be reset by carefully holding the thermometer head and turning the hex nut with a wrench to move dial in one direction or the other.
- CAUTION - Do not adjust hot thermometer with bare hands!
- CAUTION - Do not hold thermometer with bare hands while placing in boiling water as burns can result!
- CAUTION - Thermometer tip is sharp, do not leave unattended or place within reach of children.
Select a Store
Selected Store
21 locations / In stock at 21
In stock at 20 other locations
Plantation Ace Hardware
11818 Mason Rd
Richmond, TX 77406
Fulshear Ace Hardware
8411 FM 359
Fulshear, TX 77441
Ace Hardware Cinco Ranch
1720 S Mason Rd
Katy, TX 77450
360 Grills
(1 Review)
22010 Highland Knolls Dr
Katy, TX 77450
Katy Hardware
559 Pin Oak Dr.
Katy, TX 77494
Hardware City Ace
14455 Memorial Dr
Houston, TX 77079
Langham Creek Ace Hardware
18020 FM 529
Cypress, TX 77433
Cypress Ace Hardware
11655 Jones Rd
Houston, TX 77070
Pearland Lumber & Ace Hardware
2027 N Main St
Pearland, TX 77581
M & D Supply Ace Hardware
13140 Louetta Rd
Cypress, TX 77429
Spring Ace hardware
1721 Spring Cypress Rd.
Spring, TX 77388
M & D Supply Ace Hardware
2422 Bay Area Blvd. #A
Houston, TX 77058
League City Ace Hardware
1915 West League City Pkwy
League City, TX 77573
Ace Hardware of The Woodlands
10720 Kuykendahl Road
The Woodlands, TX 77381
J&R's Ace Hardware
23678 FM 1314 Rd
Porter, TX 77365
Ace Hardware Brenham
307 N Austin Pkwy
Brenham, TX 77833
Texas Grill Supply
1802 Welsh Ave
College Station, TX 77840
Sienna Ace Hardware
9320 Hwy 6
Missouri City, TX 77459
Spring Branch Ace Hardware
7840 Long Point Rd
Houston, TX 77055
Bacliff Ace Hardware
607 Grand Ave
Bacliff, TX 77518
M&D Supply Ace Hardware
12458 Eagle Dr Ste 300
Mont Belvieu, TX 77535
Directions
Contact
Website
Product Information
This high quality, stainless steel temperature gauge - with an easy-to-read dial - precisely monitors the temperatures inside the dome of an EGG, allowing you to achieve and maintain precise cooking temperatures 2 in Dial Stainless Steel External Temperature Gauge - 117236
- 750F deg / 400C deg
- Works with XXLarge, XLarge, Large, Medium, Small and MiniMax EGGs
- Heavy duty construction, hermetically sealed
- Designed and manufactured in the USA
Installation:
- Carefully insert stem from the outside through small hole in dome of the EGG; the silicone washer should remain on the outside of the EGG.
- Carefully reach inside the dome, and slide retaining clip onto the stem. Squeeze the clip so that it slides easily.
- Slide clip up the stem until the silicone washer -x001F-ts snugly against the exterior of the dome. For accurate reading, thermometer must be installed past the groove on the lower portion of stem as shown below.
This thermometer is calibrated and adjusted at the factory. If you are in high altitudes or wish to check the calibration:
- Bring a clean container of water to a boil.
- Carefully place the end of the thermometer probe into boiling water past the groove on the lower portion of stem. Leave immersed for at least one minute taking care not to let the probe rest on or make contact with the container.
- Boiling point will read 212 deg F/100 deg C at sea level. Boiling point decreases approx 2 deg with each 1000' of altitude. If the thermometer does not read 212 deg F/100 deg C at sea level, calibration can be reset by carefully holding the thermometer head and turning the hex nut with a wrench to move dial in one direction or the other.
- CAUTION - Do not adjust hot thermometer with bare hands!
- CAUTION - Do not hold thermometer with bare hands while placing in boiling water as burns can result!
- CAUTION - Thermometer tip is sharp, do not leave unattended or place within reach of children.
Product Reviews
There are no reviews yet for Big Green Egg: Temperature Gauge, 2 inch Dial .
Write a Review
