Big Green Egg
Temperature Gauge, 2 inch Dial in Naples, FL
MSRP
Product Information
This high quality, stainless steel temperature gauge - with an easy-to-read dial - precisely monitors the temperatures inside the dome of an EGG, allowing you to achieve and maintain precise cooking temperatures 2 in Dial Stainless Steel External Temperature Gauge - 117236
- 750F deg / 400C deg
- Works with XXLarge, XLarge, Large, Medium, Small and MiniMax EGGs
- Heavy duty construction, hermetically sealed
- Designed and manufactured in the USA
Installation:
- Carefully insert stem from the outside through small hole in dome of the EGG; the silicone washer should remain on the outside of the EGG.
- Carefully reach inside the dome, and slide retaining clip onto the stem. Squeeze the clip so that it slides easily.
- Slide clip up the stem until the silicone washer -x001F-ts snugly against the exterior of the dome. For accurate reading, thermometer must be installed past the groove on the lower portion of stem as shown below.
This thermometer is calibrated and adjusted at the factory. If you are in high altitudes or wish to check the calibration:
- Bring a clean container of water to a boil.
- Carefully place the end of the thermometer probe into boiling water past the groove on the lower portion of stem. Leave immersed for at least one minute taking care not to let the probe rest on or make contact with the container.
- Boiling point will read 212 deg F/100 deg C at sea level. Boiling point decreases approx 2 deg with each 1000' of altitude. If the thermometer does not read 212 deg F/100 deg C at sea level, calibration can be reset by carefully holding the thermometer head and turning the hex nut with a wrench to move dial in one direction or the other.
- CAUTION - Do not adjust hot thermometer with bare hands!
- CAUTION - Do not hold thermometer with bare hands while placing in boiling water as burns can result!
- CAUTION - Thermometer tip is sharp, do not leave unattended or place within reach of children.
Select a Store
Selected Store
19 locations / In stock at 19
In stock at 18 other locations
Sunshine Ace Hardware - Downtown Naples-Tamiami
141 Tamiami Trail North
Naples, FL 34102
Sunshine Ace Hardware - East Naples
4433 Tamiami Trail East
Naples, FL 34112
Sunshine Ace Hardware - Golden Gate
11673 Collier Blvd
Naples, FL 34116
Sunshine Ace Hardware
8850 Founders Square Dr
Naples, FL 34120
Sunshine Ace Hardware - Bonita Springs
9100 Bonita Beach Road
Bonita Springs, FL 34135
Sunshine Ace Hardware - Marco
1720 San Marco Road
Marco Island, FL 34146
Sunshine Ace Hardware - San Carlos
18911 Tamiami Trail South
Ft. Myers, FL 33912
Sunshine Ace Hardware - Ave Maria
5360 Ave Maria Blvd
Ave Maria, FL 34142
Gavin's Ace Hardware, Inc.
16025 San Carlos Blvd
Fort Myers, FL 33908
Vision Ace Hardware-Cape Coral
(1 Review)
1004 Cape Coral Pkwy.
Cape Coral, FL 33904
Gavin's Ace Hardware
290 Nicholas Parkway NW
Cape Coral, FL 33991
DG Ace Hardware
14308 Palm Beach Blvd.
Ft. Myers, FL 33905
Vision Ace Hardware - Labelle
350 W. Hickpochee Ave
Labelle, FL 33935
MRT Lawn and Garden Center
2775 El Jobean Rd
Port Charlotte, FL 33953
MRT Lawn & Garden Center
5175 Englewood Rd
Venice, FL 34293
Vision Ace Hardware
1009 N. Brevard Ave
Arcadia, FL 34266
Jacaranda Ace Hardware
337 Jacaranda Blvd
Venice, FL 34292
Indigo Pool Patio BBQ
620 Cypress Avenue
Venice, FL 34285
Ace at West Village Marketplace
12236 Mercado Dr
Venice, FL 34292
Directions
Contact
Website
Product Information
This high quality, stainless steel temperature gauge - with an easy-to-read dial - precisely monitors the temperatures inside the dome of an EGG, allowing you to achieve and maintain precise cooking temperatures 2 in Dial Stainless Steel External Temperature Gauge - 117236
- 750F deg / 400C deg
- Works with XXLarge, XLarge, Large, Medium, Small and MiniMax EGGs
- Heavy duty construction, hermetically sealed
- Designed and manufactured in the USA
Installation:
- Carefully insert stem from the outside through small hole in dome of the EGG; the silicone washer should remain on the outside of the EGG.
- Carefully reach inside the dome, and slide retaining clip onto the stem. Squeeze the clip so that it slides easily.
- Slide clip up the stem until the silicone washer -x001F-ts snugly against the exterior of the dome. For accurate reading, thermometer must be installed past the groove on the lower portion of stem as shown below.
This thermometer is calibrated and adjusted at the factory. If you are in high altitudes or wish to check the calibration:
- Bring a clean container of water to a boil.
- Carefully place the end of the thermometer probe into boiling water past the groove on the lower portion of stem. Leave immersed for at least one minute taking care not to let the probe rest on or make contact with the container.
- Boiling point will read 212 deg F/100 deg C at sea level. Boiling point decreases approx 2 deg with each 1000' of altitude. If the thermometer does not read 212 deg F/100 deg C at sea level, calibration can be reset by carefully holding the thermometer head and turning the hex nut with a wrench to move dial in one direction or the other.
- CAUTION - Do not adjust hot thermometer with bare hands!
- CAUTION - Do not hold thermometer with bare hands while placing in boiling water as burns can result!
- CAUTION - Thermometer tip is sharp, do not leave unattended or place within reach of children.
Product Reviews
There are no reviews yet for Big Green Egg: Temperature Gauge, 2 inch Dial .
Write a Review
