Big Green Egg
Temperature Gauge, 2 inch Dial in Margate, FL
MSRP
Product Information
This high quality, stainless steel temperature gauge - with an easy-to-read dial - precisely monitors the temperatures inside the dome of an EGG, allowing you to achieve and maintain precise cooking temperatures 2 in Dial Stainless Steel External Temperature Gauge - 117236
- 750F deg / 400C deg
- Works with XXLarge, XLarge, Large, Medium, Small and MiniMax EGGs
- Heavy duty construction, hermetically sealed
- Designed and manufactured in the USA
Installation:
- Carefully insert stem from the outside through small hole in dome of the EGG; the silicone washer should remain on the outside of the EGG.
- Carefully reach inside the dome, and slide retaining clip onto the stem. Squeeze the clip so that it slides easily.
- Slide clip up the stem until the silicone washer -x001F-ts snugly against the exterior of the dome. For accurate reading, thermometer must be installed past the groove on the lower portion of stem as shown below.
This thermometer is calibrated and adjusted at the factory. If you are in high altitudes or wish to check the calibration:
- Bring a clean container of water to a boil.
- Carefully place the end of the thermometer probe into boiling water past the groove on the lower portion of stem. Leave immersed for at least one minute taking care not to let the probe rest on or make contact with the container.
- Boiling point will read 212 deg F/100 deg C at sea level. Boiling point decreases approx 2 deg with each 1000' of altitude. If the thermometer does not read 212 deg F/100 deg C at sea level, calibration can be reset by carefully holding the thermometer head and turning the hex nut with a wrench to move dial in one direction or the other.
- CAUTION - Do not adjust hot thermometer with bare hands!
- CAUTION - Do not hold thermometer with bare hands while placing in boiling water as burns can result!
- CAUTION - Thermometer tip is sharp, do not leave unattended or place within reach of children.
Select a Store
Selected Store
22 locations / In stock at 22
In stock at 21 other locations
Ace Hardware-Margate
5843 Margate Blvd
Margate, FL 33063
GW Store
(1 Review)
3985 NW 19th St
Lauderdale Lakes, FL 33311
_2023-08-29-14-48-19.png){kind=logo}
Deerfield Ace Hardware
(1 Review)
365 S Federal Highway
Deerfield Beach, FL 33441
Ace Hardware Harbor Hardgoods Co.
1900 Cordova Road
Ft. Lauderdale, FL 33316
GW Store
(3 Reviews)
147 Weston Rd
Weston, FL 33326
Hessler Paint & Hardware
4591 W Atlantic Ave
Delray Beach, FL 33445
Aventura Ace Hardware
17811 Biscayne Blvd.
Aventura, FL 33160
Lantana Ace Hardware
(1 Review)
1212 Lantana Rd
Lantana, FL 33462
Rocky's Hardware-Wellington
13837 Wellington Trace
Wellington, FL 33414
Doral Ace Hardware
10758 NW 58th Street
Miami, FL 33178
Ace Hardware of Bird Road
5749 B C Bird Road
Miami, FL 33155
South Dixie Ace Hardware
6448 South Dixie Highway
South Miami, FL 33143
Palm Beach Gardens Ace Hardware
9820 Alternate A1A
Palm Beach Gardens, FL 33410
Innovative Outdoor Living
14701 Walgreens Dr Unit A
Jupiter, FL 33478
Rocky's Hardware Tequesta
584 US Highway One
Tequesta, FL 33469
Hobe Sound Ace Hardware
8863 SE Bridge Road
Hobe Sound, FL 33455
Rocky's Hardware Stuart
5899 SE Federal Hwy
Stuart, FL 34997
Rocky's Hardware Port St. Lucie
(1 Review)
7594 South US 1
Port St. Lucie, FL 34952
Sunshine Ace Hardware - Ave Maria
5360 Ave Maria Blvd
Ave Maria, FL 34142
W & W Lumber
1601 Highway 70 East
Okeechobee, FL 34972
Vision Ace Hardware - Labelle
350 W. Hickpochee Ave
Labelle, FL 33935
Miami Home Centers - South Miami
7325 SW 57th Avenue
Miami, FL 33143
Directions
Contact
Website
Product Information
This high quality, stainless steel temperature gauge - with an easy-to-read dial - precisely monitors the temperatures inside the dome of an EGG, allowing you to achieve and maintain precise cooking temperatures 2 in Dial Stainless Steel External Temperature Gauge - 117236
- 750F deg / 400C deg
- Works with XXLarge, XLarge, Large, Medium, Small and MiniMax EGGs
- Heavy duty construction, hermetically sealed
- Designed and manufactured in the USA
Installation:
- Carefully insert stem from the outside through small hole in dome of the EGG; the silicone washer should remain on the outside of the EGG.
- Carefully reach inside the dome, and slide retaining clip onto the stem. Squeeze the clip so that it slides easily.
- Slide clip up the stem until the silicone washer -x001F-ts snugly against the exterior of the dome. For accurate reading, thermometer must be installed past the groove on the lower portion of stem as shown below.
This thermometer is calibrated and adjusted at the factory. If you are in high altitudes or wish to check the calibration:
- Bring a clean container of water to a boil.
- Carefully place the end of the thermometer probe into boiling water past the groove on the lower portion of stem. Leave immersed for at least one minute taking care not to let the probe rest on or make contact with the container.
- Boiling point will read 212 deg F/100 deg C at sea level. Boiling point decreases approx 2 deg with each 1000' of altitude. If the thermometer does not read 212 deg F/100 deg C at sea level, calibration can be reset by carefully holding the thermometer head and turning the hex nut with a wrench to move dial in one direction or the other.
- CAUTION - Do not adjust hot thermometer with bare hands!
- CAUTION - Do not hold thermometer with bare hands while placing in boiling water as burns can result!
- CAUTION - Thermometer tip is sharp, do not leave unattended or place within reach of children.
Product Reviews
There are no reviews yet for Big Green Egg: Temperature Gauge, 2 inch Dial .
Write a Review
