Big Green Egg
Temperature Gauge, 2 inch Dial in Limerick, ME
MSRP
Product Information
This high quality, stainless steel temperature gauge - with an easy-to-read dial - precisely monitors the temperatures inside the dome of an EGG, allowing you to achieve and maintain precise cooking temperatures 2 in Dial Stainless Steel External Temperature Gauge - 117236
- 750F deg / 400C deg
- Works with XXLarge, XLarge, Large, Medium, Small and MiniMax EGGs
- Heavy duty construction, hermetically sealed
- Designed and manufactured in the USA
Installation:
- Carefully insert stem from the outside through small hole in dome of the EGG; the silicone washer should remain on the outside of the EGG.
- Carefully reach inside the dome, and slide retaining clip onto the stem. Squeeze the clip so that it slides easily.
- Slide clip up the stem until the silicone washer -x001F-ts snugly against the exterior of the dome. For accurate reading, thermometer must be installed past the groove on the lower portion of stem as shown below.
This thermometer is calibrated and adjusted at the factory. If you are in high altitudes or wish to check the calibration:
- Bring a clean container of water to a boil.
- Carefully place the end of the thermometer probe into boiling water past the groove on the lower portion of stem. Leave immersed for at least one minute taking care not to let the probe rest on or make contact with the container.
- Boiling point will read 212 deg F/100 deg C at sea level. Boiling point decreases approx 2 deg with each 1000' of altitude. If the thermometer does not read 212 deg F/100 deg C at sea level, calibration can be reset by carefully holding the thermometer head and turning the hex nut with a wrench to move dial in one direction or the other.
- CAUTION - Do not adjust hot thermometer with bare hands!
- CAUTION - Do not hold thermometer with bare hands while placing in boiling water as burns can result!
- CAUTION - Thermometer tip is sharp, do not leave unattended or place within reach of children.
Select a Store
Selected Store
32 locations / In stock at 32
In stock at 31 other locations
Plummer's Ace Hardware
42 Central Ave
Limerick, ME 04048
Plummer's Ace Hardware
57 Main Street
Gorham, ME 04038
Eldredge Lumber
1787 Main Street
Sanford, ME 04073
Oak Hill Ace Hardware
29 Gorham Rd
Scarborough, ME 04074
Maine Hardware
274 St. John Street
Portland, ME 04102
Falmouth Ace Hardware
215 US Rte 1
Falmouth, ME 04105
Rocky's Ace Hardware
873 Central Ave #108
Dover, NH 03820
Eldredge Lumber & Hardware
627 US Rte 1
York, ME 03909
Kittery Ace Hardware
6 Shapleigh Rd
Kittery, ME 03904
Rocky's Ace Hardware
20 Loudon Road
Concord, NH 03301
Rocky's Ace Hardware
55 Congress Ave
Bath, ME 04530
Rocky's Ace Hardware
50 Peters Street
North Andover, MA 01845
Dawson's Ace Hardware
20 Main Street
Topsfield, MA 01983
Reading Lumber
110 Main Street
North Reading, MA 01864
Westford Ace Hardware
527 Groton Road
Westford, MA 01886
Marblehead Hardware
70 Atlantic Ave
Marblehead, MA 01945
Lyndonville Hardware
583 Broad Street
Lyndonville, VT 05849
Moison Ace Hardware
143 Main Street
Groton, MA 01450
Aubuchon Hardware
1655 Route 16
Ossipee, NH 03814
Aubuchon Hardware
499 Roosevelt Trail
Naples, ME 04055
Aubuchon Hardware
7 Main Street
Alton, NH 03809
G Squared Hardware
440 Route 202
Greene, ME 04236
Aubuchon Hardware
838 Lake Street
Bristol, NH 03222
Campbell's Hardware
535 Maine Ave
Farmingdale, ME 04344
Damariscotta Hardware
423 Main Street
Damariscotta, ME 04543
Aubuchon Hardware
114 County Road
Ipswich, MA 01938
Aubuchon Hardware
528 Wilton Rd
Farmington, ME 04983
County Stores
(1 Review)
321 Nashua Street
Milford, NH 03055
Simple Energy
162 North Main Street
West Lebanon, NH 03784
Aubuchon Hardware
50 Enon Street
Beverly, MA 01915
Aubuchon Hardware
485 Kennedy Memorial Dr
Waterville, ME 04901
Campbell's Hardware
30 Garland Rd
Winslow, ME 04901
Directions
Contact
Website
Product Information
This high quality, stainless steel temperature gauge - with an easy-to-read dial - precisely monitors the temperatures inside the dome of an EGG, allowing you to achieve and maintain precise cooking temperatures 2 in Dial Stainless Steel External Temperature Gauge - 117236
- 750F deg / 400C deg
- Works with XXLarge, XLarge, Large, Medium, Small and MiniMax EGGs
- Heavy duty construction, hermetically sealed
- Designed and manufactured in the USA
Installation:
- Carefully insert stem from the outside through small hole in dome of the EGG; the silicone washer should remain on the outside of the EGG.
- Carefully reach inside the dome, and slide retaining clip onto the stem. Squeeze the clip so that it slides easily.
- Slide clip up the stem until the silicone washer -x001F-ts snugly against the exterior of the dome. For accurate reading, thermometer must be installed past the groove on the lower portion of stem as shown below.
This thermometer is calibrated and adjusted at the factory. If you are in high altitudes or wish to check the calibration:
- Bring a clean container of water to a boil.
- Carefully place the end of the thermometer probe into boiling water past the groove on the lower portion of stem. Leave immersed for at least one minute taking care not to let the probe rest on or make contact with the container.
- Boiling point will read 212 deg F/100 deg C at sea level. Boiling point decreases approx 2 deg with each 1000' of altitude. If the thermometer does not read 212 deg F/100 deg C at sea level, calibration can be reset by carefully holding the thermometer head and turning the hex nut with a wrench to move dial in one direction or the other.
- CAUTION - Do not adjust hot thermometer with bare hands!
- CAUTION - Do not hold thermometer with bare hands while placing in boiling water as burns can result!
- CAUTION - Thermometer tip is sharp, do not leave unattended or place within reach of children.
Product Reviews
There are no reviews yet for Big Green Egg: Temperature Gauge, 2 inch Dial .
Write a Review
