Big Green Egg
Temperature Gauge, 2 inch Dial in Lexington, NC
MSRP
Product Information
This high quality, stainless steel temperature gauge - with an easy-to-read dial - precisely monitors the temperatures inside the dome of an EGG, allowing you to achieve and maintain precise cooking temperatures 2 in Dial Stainless Steel External Temperature Gauge - 117236
- 750F deg / 400C deg
- Works with XXLarge, XLarge, Large, Medium, Small and MiniMax EGGs
- Heavy duty construction, hermetically sealed
- Designed and manufactured in the USA
Installation:
- Carefully insert stem from the outside through small hole in dome of the EGG; the silicone washer should remain on the outside of the EGG.
- Carefully reach inside the dome, and slide retaining clip onto the stem. Squeeze the clip so that it slides easily.
- Slide clip up the stem until the silicone washer -x001F-ts snugly against the exterior of the dome. For accurate reading, thermometer must be installed past the groove on the lower portion of stem as shown below.
This thermometer is calibrated and adjusted at the factory. If you are in high altitudes or wish to check the calibration:
- Bring a clean container of water to a boil.
- Carefully place the end of the thermometer probe into boiling water past the groove on the lower portion of stem. Leave immersed for at least one minute taking care not to let the probe rest on or make contact with the container.
- Boiling point will read 212 deg F/100 deg C at sea level. Boiling point decreases approx 2 deg with each 1000' of altitude. If the thermometer does not read 212 deg F/100 deg C at sea level, calibration can be reset by carefully holding the thermometer head and turning the hex nut with a wrench to move dial in one direction or the other.
- CAUTION - Do not adjust hot thermometer with bare hands!
- CAUTION - Do not hold thermometer with bare hands while placing in boiling water as burns can result!
- CAUTION - Thermometer tip is sharp, do not leave unattended or place within reach of children.
Select a Store
Selected Store
21 locations / In stock at 21
In stock at 20 other locations
Lanier's Ace Hardware
218 S Main St
Lexington, NC 27293
Steelman's Ace Hardware
5431 US Hwy 158
Advance, NC 27006
Northwest Ace Hardware - Winston Salem
3450 Robinhood Road
Winston Salem, NC 27106
Pointer's Ace Hardware
775 Concord Pkwy N
Concord, NC 28027
Stoney Creek Ace Hardware
941 Center Crest Dr
Whitsett, NC 27377
Locust Ace Hardware
217 Town Centre Dr.
Locust, NC 28097
Blackhawk Hardware
4225 Park Road Shopping Center
Charlotte, NC 28209
Ace Hardware Indian Trail
(1 Review)
205 Indian Trail Rd
Indian Trail, NC 28079
Northwest Ace Hardware
1188 Mica Road
Ridgeway, VA 24148
Northwest Hardware - Hickory
3347 S NC 127 Hwy
Hickory, NC 28602
Westlake Ace Hardware-Chapel Hill
157 Chatham Downs Dr
Chapel Hill, NC 27517
Waxhaw Ace Hardware
3927 Providence Rd South
Waxhaw, NC 28173
Northwest Ace Hardware-Morganton
526 W Fleming Dr
Morganton, NC 28655
Westlake Ace Hardware - Cary
2976 Kildaire Farm Rd.
Cary, NC 27518
Westlake Ace Hardware - High Point
1589 Skeet Club Rd
High Point, NC 27265
Northwest Ace of Walkertown
2700 Old Hollow Rd
Walkertown, NC 27051
Ace Hardware - Mint Hill
6912 Matthews - Mint Hill Rd
Mint Hill, NC 28227
Westlake Ace Hardware
2924 Mt Holly Huntersville Rd
Charlotte, NC 28214
Westlake Ace of Charlotte
15221 John J Delaney Dr
Charlotte, NC 28277
McCaffety Ace Hardware
1761 Neal Hawkins Rd
Gastonia, NC 28056
Carrol Ace Hardware of Fort Mill
1785 Gold Hill Rd
Fort Mill, SC 29708
Directions
Contact
Website
Product Information
This high quality, stainless steel temperature gauge - with an easy-to-read dial - precisely monitors the temperatures inside the dome of an EGG, allowing you to achieve and maintain precise cooking temperatures 2 in Dial Stainless Steel External Temperature Gauge - 117236
- 750F deg / 400C deg
- Works with XXLarge, XLarge, Large, Medium, Small and MiniMax EGGs
- Heavy duty construction, hermetically sealed
- Designed and manufactured in the USA
Installation:
- Carefully insert stem from the outside through small hole in dome of the EGG; the silicone washer should remain on the outside of the EGG.
- Carefully reach inside the dome, and slide retaining clip onto the stem. Squeeze the clip so that it slides easily.
- Slide clip up the stem until the silicone washer -x001F-ts snugly against the exterior of the dome. For accurate reading, thermometer must be installed past the groove on the lower portion of stem as shown below.
This thermometer is calibrated and adjusted at the factory. If you are in high altitudes or wish to check the calibration:
- Bring a clean container of water to a boil.
- Carefully place the end of the thermometer probe into boiling water past the groove on the lower portion of stem. Leave immersed for at least one minute taking care not to let the probe rest on or make contact with the container.
- Boiling point will read 212 deg F/100 deg C at sea level. Boiling point decreases approx 2 deg with each 1000' of altitude. If the thermometer does not read 212 deg F/100 deg C at sea level, calibration can be reset by carefully holding the thermometer head and turning the hex nut with a wrench to move dial in one direction or the other.
- CAUTION - Do not adjust hot thermometer with bare hands!
- CAUTION - Do not hold thermometer with bare hands while placing in boiling water as burns can result!
- CAUTION - Thermometer tip is sharp, do not leave unattended or place within reach of children.
Product Reviews
There are no reviews yet for Big Green Egg: Temperature Gauge, 2 inch Dial .
Write a Review
