Big Green Egg
Temperature Gauge, 2 inch Dial in Kewaskum, WI 53040
MSRP
Product Information
This high quality, stainless steel temperature gauge - with an easy-to-read dial - precisely monitors the temperatures inside the dome of an EGG, allowing you to achieve and maintain precise cooking temperatures 2 in Dial Stainless Steel External Temperature Gauge - 117236
- 750F deg / 400C deg
- Works with XXLarge, XLarge, Large, Medium, Small and MiniMax EGGs
- Heavy duty construction, hermetically sealed
- Designed and manufactured in the USA
Installation:
- Carefully insert stem from the outside through small hole in dome of the EGG; the silicone washer should remain on the outside of the EGG.
- Carefully reach inside the dome, and slide retaining clip onto the stem. Squeeze the clip so that it slides easily.
- Slide clip up the stem until the silicone washer -x001F-ts snugly against the exterior of the dome. For accurate reading, thermometer must be installed past the groove on the lower portion of stem as shown below.
This thermometer is calibrated and adjusted at the factory. If you are in high altitudes or wish to check the calibration:
- Bring a clean container of water to a boil.
- Carefully place the end of the thermometer probe into boiling water past the groove on the lower portion of stem. Leave immersed for at least one minute taking care not to let the probe rest on or make contact with the container.
- Boiling point will read 212 deg F/100 deg C at sea level. Boiling point decreases approx 2 deg with each 1000' of altitude. If the thermometer does not read 212 deg F/100 deg C at sea level, calibration can be reset by carefully holding the thermometer head and turning the hex nut with a wrench to move dial in one direction or the other.
- CAUTION - Do not adjust hot thermometer with bare hands!
- CAUTION - Do not hold thermometer with bare hands while placing in boiling water as burns can result!
- CAUTION - Thermometer tip is sharp, do not leave unattended or place within reach of children.
Select a Store
Selected Store
20 locations / In stock at 20
In stock at 19 other locations
Tennies Ace Hardware
900 Fond Du Lac Ave
Kewaskum, WI 53040
Hahn Ace Hardware
2945 State Road 83
Hartford, WI 53027
Ozaukee Ace Hardware
1818 Wisconsin Ave
Grafton, WI 53024
Ace Hardware of Oconomowoc
1081 Summit Ave
Oconomowoc, WI 53066
Hahn Ace Hardware
2835 Heritage Dr
Delafield, WI 53018
TNT Ace Hardware
212 E Sunset Dr
Waukesha, WI 53189
Kitz & Pfeil Oshkosh
427 N Main St
Oshkosh, WI 54901
Harry's Ace Hardware
7240 S. 76th St.
Franklin, WI 53132
Kitz & Pfeil Hardware Appleton
1919 E. Calumet
Appleton, WI 54915
Scheels -Appleton
4301 W Wisconsin Ave
Appleton, WI 54913
Ace Hardware of Appleton
500 E Northland Ave
Appleton, WI 54911
Kimps Ace Hardware of Ashwaubenon
2110 S Ridge Rd
Green Bay, WI 54304
Ace Hilldale
414 N Midvale Blvd
Madison, WI 53705
Kimps Ace Hardware
2548 Glendale Ave
Green Bay, WI 54313
Gurnee Ace Hardware
4806 Grand Ave
Gurnee, IL 60031
Ace Hardware Home Center
659 Railroad Ave
Round Lake, IL 60073
Ace Hardware
4520 W Crystal Lake Rd
McHenry, IL 60050
Ace Hardware
945 E Belvidere Rd
Grayslake, IL 60030
Brazee Ace Hardware of Winneconne
926 E Main Street
Winneconne, WI 54986
Ace Hardware 653
617 Linn St
Baraboo, WI 53913
Directions
Contact
Website
Product Information
This high quality, stainless steel temperature gauge - with an easy-to-read dial - precisely monitors the temperatures inside the dome of an EGG, allowing you to achieve and maintain precise cooking temperatures 2 in Dial Stainless Steel External Temperature Gauge - 117236
- 750F deg / 400C deg
- Works with XXLarge, XLarge, Large, Medium, Small and MiniMax EGGs
- Heavy duty construction, hermetically sealed
- Designed and manufactured in the USA
Installation:
- Carefully insert stem from the outside through small hole in dome of the EGG; the silicone washer should remain on the outside of the EGG.
- Carefully reach inside the dome, and slide retaining clip onto the stem. Squeeze the clip so that it slides easily.
- Slide clip up the stem until the silicone washer -x001F-ts snugly against the exterior of the dome. For accurate reading, thermometer must be installed past the groove on the lower portion of stem as shown below.
This thermometer is calibrated and adjusted at the factory. If you are in high altitudes or wish to check the calibration:
- Bring a clean container of water to a boil.
- Carefully place the end of the thermometer probe into boiling water past the groove on the lower portion of stem. Leave immersed for at least one minute taking care not to let the probe rest on or make contact with the container.
- Boiling point will read 212 deg F/100 deg C at sea level. Boiling point decreases approx 2 deg with each 1000' of altitude. If the thermometer does not read 212 deg F/100 deg C at sea level, calibration can be reset by carefully holding the thermometer head and turning the hex nut with a wrench to move dial in one direction or the other.
- CAUTION - Do not adjust hot thermometer with bare hands!
- CAUTION - Do not hold thermometer with bare hands while placing in boiling water as burns can result!
- CAUTION - Thermometer tip is sharp, do not leave unattended or place within reach of children.
Product Reviews
There are no reviews yet for Big Green Egg: Temperature Gauge, 2 inch Dial .
Write a Review
