Big Green Egg
Temperature Gauge, 2 inch Dial in Healdsburg, CA 95448
MSRP
Product Information
This high quality, stainless steel temperature gauge - with an easy-to-read dial - precisely monitors the temperatures inside the dome of an EGG, allowing you to achieve and maintain precise cooking temperatures 2 in Dial Stainless Steel External Temperature Gauge - 117236
- 750F deg / 400C deg
- Works with XXLarge, XLarge, Large, Medium, Small and MiniMax EGGs
- Heavy duty construction, hermetically sealed
- Designed and manufactured in the USA
Installation:
- Carefully insert stem from the outside through small hole in dome of the EGG; the silicone washer should remain on the outside of the EGG.
- Carefully reach inside the dome, and slide retaining clip onto the stem. Squeeze the clip so that it slides easily.
- Slide clip up the stem until the silicone washer -x001F-ts snugly against the exterior of the dome. For accurate reading, thermometer must be installed past the groove on the lower portion of stem as shown below.
This thermometer is calibrated and adjusted at the factory. If you are in high altitudes or wish to check the calibration:
- Bring a clean container of water to a boil.
- Carefully place the end of the thermometer probe into boiling water past the groove on the lower portion of stem. Leave immersed for at least one minute taking care not to let the probe rest on or make contact with the container.
- Boiling point will read 212 deg F/100 deg C at sea level. Boiling point decreases approx 2 deg with each 1000' of altitude. If the thermometer does not read 212 deg F/100 deg C at sea level, calibration can be reset by carefully holding the thermometer head and turning the hex nut with a wrench to move dial in one direction or the other.
- CAUTION - Do not adjust hot thermometer with bare hands!
- CAUTION - Do not hold thermometer with bare hands while placing in boiling water as burns can result!
- CAUTION - Thermometer tip is sharp, do not leave unattended or place within reach of children.
Select a Store
Selected Store
22 locations / In stock at 22
In stock at 21 other locations
Garrett Ace Hardware
1340 Healdsburg Ave
Healdsburg, CA 95448
Garrett Ace Hardware
10540 Old Redwood Hwy
Windsor, CA 95492
Westlake Ace Hardware
2551 Guerneville Rd
Santa Rosa, CA 95401
Jackson's Hardware
62 Woodland Ave
San Rafael, CA 94901
Ace Hardware of Pinole
1440 Fitzgerald Dr
Pinole, CA 94564
Goodman Building Supply
775 Redwood Highway
Mill Valley, CA 94941
Dixon Ace Hardware & Lumber
1505 N 1st Street
Dixon, CA 95620
Westlake Ace Hardware #149
1350 E Main Street
Woodland, CA 95776
Standard 5 & 10 Ace
3545 California St
San Francisco, CA 94118
Davis Ace Hardware
815 3rd Street
Davis, CA 95616
Cole Hardware - Rockridge
5533 College Ave
Oakland, CA 94618
Ace Hardware of Pleasant Hill
1530 Contra Costa Blvd
Pleasant Hill, CA 94523
Downtown Walnut Creek Ace Hardware
2044 Mt. Diablo Blvd
Walnut Creek, CA 94596
Hassett Hardware Linda Mar
560 San Pedro Ave
Pacifica, CA 94044
Oakley Ace Hardware
3100 Main Street #266
Oakley, CA 94561
Hassett Ace Hardware
545 First Ave
San Mateo, CA 94401
Brentwood Ace Hardware
8900 Brentwood Blvd
Brentwood, CA 94513
Hassett Ace Hardware
1029 Alameda De Las Pulgas
Belmont, CA 94002
Hassett Ace hardware
111 Main Street
Half Moon Bay, CA 94019
Candelario Ace Hardware
1626 State Hwy 99
Gridley, CA 95948
Outdoor Supply Hardware
1025 Ashby Ave
Berkeley, CA 94710
Westlake Ace Hardware - San Leandro
699 Lewelling Blvd
San Leandro, CA 94579
Directions
Contact
Website
Product Information
This high quality, stainless steel temperature gauge - with an easy-to-read dial - precisely monitors the temperatures inside the dome of an EGG, allowing you to achieve and maintain precise cooking temperatures 2 in Dial Stainless Steel External Temperature Gauge - 117236
- 750F deg / 400C deg
- Works with XXLarge, XLarge, Large, Medium, Small and MiniMax EGGs
- Heavy duty construction, hermetically sealed
- Designed and manufactured in the USA
Installation:
- Carefully insert stem from the outside through small hole in dome of the EGG; the silicone washer should remain on the outside of the EGG.
- Carefully reach inside the dome, and slide retaining clip onto the stem. Squeeze the clip so that it slides easily.
- Slide clip up the stem until the silicone washer -x001F-ts snugly against the exterior of the dome. For accurate reading, thermometer must be installed past the groove on the lower portion of stem as shown below.
This thermometer is calibrated and adjusted at the factory. If you are in high altitudes or wish to check the calibration:
- Bring a clean container of water to a boil.
- Carefully place the end of the thermometer probe into boiling water past the groove on the lower portion of stem. Leave immersed for at least one minute taking care not to let the probe rest on or make contact with the container.
- Boiling point will read 212 deg F/100 deg C at sea level. Boiling point decreases approx 2 deg with each 1000' of altitude. If the thermometer does not read 212 deg F/100 deg C at sea level, calibration can be reset by carefully holding the thermometer head and turning the hex nut with a wrench to move dial in one direction or the other.
- CAUTION - Do not adjust hot thermometer with bare hands!
- CAUTION - Do not hold thermometer with bare hands while placing in boiling water as burns can result!
- CAUTION - Thermometer tip is sharp, do not leave unattended or place within reach of children.
Product Reviews
There are no reviews yet for Big Green Egg: Temperature Gauge, 2 inch Dial .
Write a Review
