Big Green Egg
Temperature Gauge, 2 inch Dial in Granite Bay, CA
MSRP
Product Information
This high quality, stainless steel temperature gauge - with an easy-to-read dial - precisely monitors the temperatures inside the dome of an EGG, allowing you to achieve and maintain precise cooking temperatures 2 in Dial Stainless Steel External Temperature Gauge - 117236
- 750F deg / 400C deg
- Works with XXLarge, XLarge, Large, Medium, Small and MiniMax EGGs
- Heavy duty construction, hermetically sealed
- Designed and manufactured in the USA
Installation:
- Carefully insert stem from the outside through small hole in dome of the EGG; the silicone washer should remain on the outside of the EGG.
- Carefully reach inside the dome, and slide retaining clip onto the stem. Squeeze the clip so that it slides easily.
- Slide clip up the stem until the silicone washer -x001F-ts snugly against the exterior of the dome. For accurate reading, thermometer must be installed past the groove on the lower portion of stem as shown below.
This thermometer is calibrated and adjusted at the factory. If you are in high altitudes or wish to check the calibration:
- Bring a clean container of water to a boil.
- Carefully place the end of the thermometer probe into boiling water past the groove on the lower portion of stem. Leave immersed for at least one minute taking care not to let the probe rest on or make contact with the container.
- Boiling point will read 212 deg F/100 deg C at sea level. Boiling point decreases approx 2 deg with each 1000' of altitude. If the thermometer does not read 212 deg F/100 deg C at sea level, calibration can be reset by carefully holding the thermometer head and turning the hex nut with a wrench to move dial in one direction or the other.
- CAUTION - Do not adjust hot thermometer with bare hands!
- CAUTION - Do not hold thermometer with bare hands while placing in boiling water as burns can result!
- CAUTION - Thermometer tip is sharp, do not leave unattended or place within reach of children.
Select a Store
Selected Store
22 locations / In stock at 22
In stock at 21 other locations
Granite Bay Ace Hardware
8665 Auburn Folsom Rd.
Granite Bay, CA 95746
Loomis Ace Hardware
3690 Taylor Road
Loomis, CA 95650
Roseville Ace Hardware
(1 Review)
108A Harding Blvd
Roseville, CA 95678
Hills Flat Lumber - Grass Valley
380 Railroad Ave
Grass Valley, CA 95945
Westlake Ace Hardware #149
1350 E Main Street
Woodland, CA 95776
Davis Ace Hardware
815 3rd Street
Davis, CA 95616
Dixon Ace Hardware & Lumber
1505 N 1st Street
Dixon, CA 95620
Candelario Ace Hardware
1626 State Hwy 99
Gridley, CA 95948
Stockton Ace Hardware
3201 W. Benjamin Holt Dr.
Stockton, CA 95219
Oakley Ace Hardware
3100 Main Street #266
Oakley, CA 94561
Brentwood Ace Hardware
8900 Brentwood Blvd
Brentwood, CA 94513
Strand Ace Hardware
189 W Louise Ave
Mantica, CA 95336
Strand Ace Hardware
150 North Wilma Ave
Ripon, CA 95366
Strand Ace Hardware
1010 East F Street
Oakdale, CA 95361
Van's Ace Hardware
2695 North Tracy Blvd
Tracy, CA 95376
Ace Hardware of Pleasant Hill
1530 Contra Costa Blvd
Pleasant Hill, CA 94523
Strand Ace Hardware
1800 Oakdale Rd
Modesto, CA 95355
Downtown Walnut Creek Ace Hardware
2044 Mt. Diablo Blvd
Walnut Creek, CA 94596
Westlake Ace Hardware
231 West East Ave
Chico, CA 95926
Ace Hardware of Pinole
1440 Fitzgerald Dr
Pinole, CA 94564
Westlake Ace Hardware
1450 First Street
Livermore, CA 94550
Miller's Ace Hardware
8077 Madison Ave
Citrus Heights, CA 95610
Directions
Contact
Website
Product Information
This high quality, stainless steel temperature gauge - with an easy-to-read dial - precisely monitors the temperatures inside the dome of an EGG, allowing you to achieve and maintain precise cooking temperatures 2 in Dial Stainless Steel External Temperature Gauge - 117236
- 750F deg / 400C deg
- Works with XXLarge, XLarge, Large, Medium, Small and MiniMax EGGs
- Heavy duty construction, hermetically sealed
- Designed and manufactured in the USA
Installation:
- Carefully insert stem from the outside through small hole in dome of the EGG; the silicone washer should remain on the outside of the EGG.
- Carefully reach inside the dome, and slide retaining clip onto the stem. Squeeze the clip so that it slides easily.
- Slide clip up the stem until the silicone washer -x001F-ts snugly against the exterior of the dome. For accurate reading, thermometer must be installed past the groove on the lower portion of stem as shown below.
This thermometer is calibrated and adjusted at the factory. If you are in high altitudes or wish to check the calibration:
- Bring a clean container of water to a boil.
- Carefully place the end of the thermometer probe into boiling water past the groove on the lower portion of stem. Leave immersed for at least one minute taking care not to let the probe rest on or make contact with the container.
- Boiling point will read 212 deg F/100 deg C at sea level. Boiling point decreases approx 2 deg with each 1000' of altitude. If the thermometer does not read 212 deg F/100 deg C at sea level, calibration can be reset by carefully holding the thermometer head and turning the hex nut with a wrench to move dial in one direction or the other.
- CAUTION - Do not adjust hot thermometer with bare hands!
- CAUTION - Do not hold thermometer with bare hands while placing in boiling water as burns can result!
- CAUTION - Thermometer tip is sharp, do not leave unattended or place within reach of children.
Product Reviews
There are no reviews yet for Big Green Egg: Temperature Gauge, 2 inch Dial .
Write a Review
