Big Green Egg
Temperature Gauge, 2 inch Dial in Gilbert, AZ
MSRP
Product Information
This high quality, stainless steel temperature gauge - with an easy-to-read dial - precisely monitors the temperatures inside the dome of an EGG, allowing you to achieve and maintain precise cooking temperatures 2 in Dial Stainless Steel External Temperature Gauge - 117236
- 750F deg / 400C deg
- Works with XXLarge, XLarge, Large, Medium, Small and MiniMax EGGs
- Heavy duty construction, hermetically sealed
- Designed and manufactured in the USA
Installation:
- Carefully insert stem from the outside through small hole in dome of the EGG; the silicone washer should remain on the outside of the EGG.
- Carefully reach inside the dome, and slide retaining clip onto the stem. Squeeze the clip so that it slides easily.
- Slide clip up the stem until the silicone washer -x001F-ts snugly against the exterior of the dome. For accurate reading, thermometer must be installed past the groove on the lower portion of stem as shown below.
This thermometer is calibrated and adjusted at the factory. If you are in high altitudes or wish to check the calibration:
- Bring a clean container of water to a boil.
- Carefully place the end of the thermometer probe into boiling water past the groove on the lower portion of stem. Leave immersed for at least one minute taking care not to let the probe rest on or make contact with the container.
- Boiling point will read 212 deg F/100 deg C at sea level. Boiling point decreases approx 2 deg with each 1000' of altitude. If the thermometer does not read 212 deg F/100 deg C at sea level, calibration can be reset by carefully holding the thermometer head and turning the hex nut with a wrench to move dial in one direction or the other.
- CAUTION - Do not adjust hot thermometer with bare hands!
- CAUTION - Do not hold thermometer with bare hands while placing in boiling water as burns can result!
- CAUTION - Thermometer tip is sharp, do not leave unattended or place within reach of children.
Select a Store
Selected Store
18 locations / In stock at 18
In stock at 17 other locations
Ace Hardware of Gilbert
(1 Review)
3232 E Guadalupe Rd
Gilbert, AZ 85234
Paul's Ace Hardware
1153 W Broadway Road
Tempe, AZ 85282
Ace Hardware & Rental
4825 E Warner Rd
Phoenix, AZ 85044
Paul's Ace Hardware
8449 E McDonald Dr
Scottsdale, AZ 85250
Paul's Ace Hardware
11323 E Via Linda
Scottsdale, AZ 85259
Barry's Ace Hardware
6841 S Central Ave
Phoenix, AZ 85042
Ace Hardware & Rental - Scottsdale
10300 N Scottsdale Rd
Scottsdale, AZ 85253
Paul's Ace Hardware
16605 E Palisades Parkway
Fountain Hills, AZ 85268
Barry's Ace Hardware
7820 N 12th Street
Phoenix, AZ 85020
Artie's Ace Hardware
13811 N Tatum Blvd
Phoenix, AZ 85032
Barry's Ace Hardware
1929 W Glendale Ave
Phoenix, AZ 85021
Ace Hardware Union Hills
18416 N 19th Ave.
Phoenix, AZ 85023
Karsten's Ace Hardware
28220 N Tatum Blvd
Cave Creek, AZ 85331
Floyd's Hardware
13820 W Camelback
Litchfield Park, AZ 85340
Karsten's Ace Hardware
610 N Estella Parkway
Goodyear, AZ 85338
Hometown Ace Hardware
19570 W Indian School Rd
Buckeye, AZ 85396
Cooley Station Ace Hardware
4115 E Williams Field Rd
Gilbert, AZ 85295
Mark's Ace Hardware
9705 N Thornydale Rd
Tucson, AZ 85742
Directions
Contact
Website
Product Information
This high quality, stainless steel temperature gauge - with an easy-to-read dial - precisely monitors the temperatures inside the dome of an EGG, allowing you to achieve and maintain precise cooking temperatures 2 in Dial Stainless Steel External Temperature Gauge - 117236
- 750F deg / 400C deg
- Works with XXLarge, XLarge, Large, Medium, Small and MiniMax EGGs
- Heavy duty construction, hermetically sealed
- Designed and manufactured in the USA
Installation:
- Carefully insert stem from the outside through small hole in dome of the EGG; the silicone washer should remain on the outside of the EGG.
- Carefully reach inside the dome, and slide retaining clip onto the stem. Squeeze the clip so that it slides easily.
- Slide clip up the stem until the silicone washer -x001F-ts snugly against the exterior of the dome. For accurate reading, thermometer must be installed past the groove on the lower portion of stem as shown below.
This thermometer is calibrated and adjusted at the factory. If you are in high altitudes or wish to check the calibration:
- Bring a clean container of water to a boil.
- Carefully place the end of the thermometer probe into boiling water past the groove on the lower portion of stem. Leave immersed for at least one minute taking care not to let the probe rest on or make contact with the container.
- Boiling point will read 212 deg F/100 deg C at sea level. Boiling point decreases approx 2 deg with each 1000' of altitude. If the thermometer does not read 212 deg F/100 deg C at sea level, calibration can be reset by carefully holding the thermometer head and turning the hex nut with a wrench to move dial in one direction or the other.
- CAUTION - Do not adjust hot thermometer with bare hands!
- CAUTION - Do not hold thermometer with bare hands while placing in boiling water as burns can result!
- CAUTION - Thermometer tip is sharp, do not leave unattended or place within reach of children.
Product Reviews
There are no reviews yet for Big Green Egg: Temperature Gauge, 2 inch Dial .
Write a Review
