Big Green Egg
Temperature Gauge, 2 inch Dial in Eureka, MO
MSRP
Product Information
This high quality, stainless steel temperature gauge - with an easy-to-read dial - precisely monitors the temperatures inside the dome of an EGG, allowing you to achieve and maintain precise cooking temperatures 2 in Dial Stainless Steel External Temperature Gauge - 117236
- 750F deg / 400C deg
- Works with XXLarge, XLarge, Large, Medium, Small and MiniMax EGGs
- Heavy duty construction, hermetically sealed
- Designed and manufactured in the USA
Installation:
- Carefully insert stem from the outside through small hole in dome of the EGG; the silicone washer should remain on the outside of the EGG.
- Carefully reach inside the dome, and slide retaining clip onto the stem. Squeeze the clip so that it slides easily.
- Slide clip up the stem until the silicone washer -x001F-ts snugly against the exterior of the dome. For accurate reading, thermometer must be installed past the groove on the lower portion of stem as shown below.
This thermometer is calibrated and adjusted at the factory. If you are in high altitudes or wish to check the calibration:
- Bring a clean container of water to a boil.
- Carefully place the end of the thermometer probe into boiling water past the groove on the lower portion of stem. Leave immersed for at least one minute taking care not to let the probe rest on or make contact with the container.
- Boiling point will read 212 deg F/100 deg C at sea level. Boiling point decreases approx 2 deg with each 1000' of altitude. If the thermometer does not read 212 deg F/100 deg C at sea level, calibration can be reset by carefully holding the thermometer head and turning the hex nut with a wrench to move dial in one direction or the other.
- CAUTION - Do not adjust hot thermometer with bare hands!
- CAUTION - Do not hold thermometer with bare hands while placing in boiling water as burns can result!
- CAUTION - Thermometer tip is sharp, do not leave unattended or place within reach of children.
Select a Store
Selected Store
19 locations / In stock at 19
In stock at 18 other locations
Cotton's Ace Hardware
111 Hilltop Village Center Dr
Eureka, MO 63025
Rick's Ace Hardware
15870 Clayton Rd
Ellisville, MO 63011
Rick's Ace Hardware
221 Lamp and Lantern Village
Chesterfield, MO 63017
Westlake Hardware 94
9065 Watson Rd
Crestwood, MO 63126
Westlake Ace Hardware 97
8740 Manchester Rd
Brentwood, MO 63144
Westlake Hardware
12634 Dorsett Rd
Maryland Heights, MO 63043
Westlake Ace Hardware
915 Jungermann Rd
St. Peters, MO 63376
Westlake Hardware 72
810 Washington Corners
Washington, MO 63090
Home Brite Ace Hardware
400 N Illinois St
Belleville, IL 62220
Cotton's Ace Hardware of Collinsville
501 Belt Line Rd Suite 20
Collinsville, IL 62234
Ace Hardware
1 Airway Court
Bethalto, IL 62010
Rick's Ace Hardware
2654 Northtown Way
Highland, IL 62249
Westlake ACE Hardware #3
(1 Review)
206 E Second St
Fulton, MO 65251
Great Lakes Ace Hardware
901 W Fayette St
Pittsfield, IL 62363
Westlake Hardware 9
700 West Jackson
Mexico, MO 65265
Westlake Ace Hardware 170
1144 Meramec Station Rd
Ballwin, MO 63021
Rick's Ace Hardware
5437 Southwest Ave
St. Louis, MO 63139
Town & Country Ace
910 N Jefferson St
St James, MO 65559
Ken's Ace Hardware
1405 Old Saint Marys Rd
Perryville, MO 63775
Directions
Contact
Website
Product Information
This high quality, stainless steel temperature gauge - with an easy-to-read dial - precisely monitors the temperatures inside the dome of an EGG, allowing you to achieve and maintain precise cooking temperatures 2 in Dial Stainless Steel External Temperature Gauge - 117236
- 750F deg / 400C deg
- Works with XXLarge, XLarge, Large, Medium, Small and MiniMax EGGs
- Heavy duty construction, hermetically sealed
- Designed and manufactured in the USA
Installation:
- Carefully insert stem from the outside through small hole in dome of the EGG; the silicone washer should remain on the outside of the EGG.
- Carefully reach inside the dome, and slide retaining clip onto the stem. Squeeze the clip so that it slides easily.
- Slide clip up the stem until the silicone washer -x001F-ts snugly against the exterior of the dome. For accurate reading, thermometer must be installed past the groove on the lower portion of stem as shown below.
This thermometer is calibrated and adjusted at the factory. If you are in high altitudes or wish to check the calibration:
- Bring a clean container of water to a boil.
- Carefully place the end of the thermometer probe into boiling water past the groove on the lower portion of stem. Leave immersed for at least one minute taking care not to let the probe rest on or make contact with the container.
- Boiling point will read 212 deg F/100 deg C at sea level. Boiling point decreases approx 2 deg with each 1000' of altitude. If the thermometer does not read 212 deg F/100 deg C at sea level, calibration can be reset by carefully holding the thermometer head and turning the hex nut with a wrench to move dial in one direction or the other.
- CAUTION - Do not adjust hot thermometer with bare hands!
- CAUTION - Do not hold thermometer with bare hands while placing in boiling water as burns can result!
- CAUTION - Thermometer tip is sharp, do not leave unattended or place within reach of children.
Product Reviews
There are no reviews yet for Big Green Egg: Temperature Gauge, 2 inch Dial .
Write a Review
