Big Green Egg
Temperature Gauge, 2 inch Dial in Cincinnati, OH
MSRP
Product Information
This high quality, stainless steel temperature gauge - with an easy-to-read dial - precisely monitors the temperatures inside the dome of an EGG, allowing you to achieve and maintain precise cooking temperatures 2 in Dial Stainless Steel External Temperature Gauge - 117236
- 750F deg / 400C deg
- Works with XXLarge, XLarge, Large, Medium, Small and MiniMax EGGs
- Heavy duty construction, hermetically sealed
- Designed and manufactured in the USA
Installation:
- Carefully insert stem from the outside through small hole in dome of the EGG; the silicone washer should remain on the outside of the EGG.
- Carefully reach inside the dome, and slide retaining clip onto the stem. Squeeze the clip so that it slides easily.
- Slide clip up the stem until the silicone washer -x001F-ts snugly against the exterior of the dome. For accurate reading, thermometer must be installed past the groove on the lower portion of stem as shown below.
This thermometer is calibrated and adjusted at the factory. If you are in high altitudes or wish to check the calibration:
- Bring a clean container of water to a boil.
- Carefully place the end of the thermometer probe into boiling water past the groove on the lower portion of stem. Leave immersed for at least one minute taking care not to let the probe rest on or make contact with the container.
- Boiling point will read 212 deg F/100 deg C at sea level. Boiling point decreases approx 2 deg with each 1000' of altitude. If the thermometer does not read 212 deg F/100 deg C at sea level, calibration can be reset by carefully holding the thermometer head and turning the hex nut with a wrench to move dial in one direction or the other.
- CAUTION - Do not adjust hot thermometer with bare hands!
- CAUTION - Do not hold thermometer with bare hands while placing in boiling water as burns can result!
- CAUTION - Thermometer tip is sharp, do not leave unattended or place within reach of children.
Select a Store
Selected Store
24 locations / In stock at 24
In stock at 23 other locations
Great Lakes Ace
82D Carothers Rd
Newport, KY 41071
Hyde Park Ace Hardware
3812 Paxton Ave.
Cincinnati, OH 45209
Ace Hardware Mariemont
7201 Wooster Pike
Cincinnati, OH 45227
Great Lakes Ace Hardware
3545 N Bend Rd
Hebron, KY 41048
Great Lakes Ace Hardware
8515 US Hwy 42
Florence, KY 41042
Ace Hardware Loveland
675 Loveland Madeira Rd
Loveland, OH 45140
Ace Hardware - West Chester
7852 Cincinnati Dayton Rd
West Chester Township, OH 45069
E&H Ace Hardware
1500 Plaza Dr
Hamilton, OH 45013
Ace Hardware Hamilton
4185 Tonya Trail
Hamilton, OH 45011
Handyman Ace Hardware
508 S Burnett Rd
Springfield, OH 45505
Handyman Ace Hardware
165 S Orange St
Xenia, OH 45385
Handyman Ace Hardware
122 E Dayton Yellow Springs Road
Fairborn, OH 45324
Wilmington Ace Hardware
1268 Rombach Ave
Wilmington, OH 45177
Handyman Ace Hardware
3300 S Dayton Lakeview Rd
New Carlisle, OH 45344
Handyman Ace Hardware
1950 E Stroop Road
Kettering, OH 45429
Rocky's Handyman Ace
1229 Wilmington Ave
Dayton, OH 45420
Handyman Ace Hardware
7845 Clyo Road
Centerville, OH 45459
Brownsboro Hardware and Paint
9521 US Hwy 42
Prospect, KY 40059
Lebanon Ace Hardware
729 East Main Street
Lebanon, OH 45036
Ace Hardware
3120 Pimlico Pkwy
Lexington, KY 40517
Brownsboro Hardware & Paint
4858 Brownsboro Road
Louisville, KY 40207
Preble Co Ace Hardware
1104 N Barron St
Eaton, OH 45320
Great Lakes Ace Cincinnati
8449 Winton Rd
Cincinnati, OH 45231
Great Lakes Ace Hardware
170 Bellerive Blvd
Nicholasville, KY 40356
Product Information
This high quality, stainless steel temperature gauge - with an easy-to-read dial - precisely monitors the temperatures inside the dome of an EGG, allowing you to achieve and maintain precise cooking temperatures 2 in Dial Stainless Steel External Temperature Gauge - 117236
- 750F deg / 400C deg
- Works with XXLarge, XLarge, Large, Medium, Small and MiniMax EGGs
- Heavy duty construction, hermetically sealed
- Designed and manufactured in the USA
Installation:
- Carefully insert stem from the outside through small hole in dome of the EGG; the silicone washer should remain on the outside of the EGG.
- Carefully reach inside the dome, and slide retaining clip onto the stem. Squeeze the clip so that it slides easily.
- Slide clip up the stem until the silicone washer -x001F-ts snugly against the exterior of the dome. For accurate reading, thermometer must be installed past the groove on the lower portion of stem as shown below.
This thermometer is calibrated and adjusted at the factory. If you are in high altitudes or wish to check the calibration:
- Bring a clean container of water to a boil.
- Carefully place the end of the thermometer probe into boiling water past the groove on the lower portion of stem. Leave immersed for at least one minute taking care not to let the probe rest on or make contact with the container.
- Boiling point will read 212 deg F/100 deg C at sea level. Boiling point decreases approx 2 deg with each 1000' of altitude. If the thermometer does not read 212 deg F/100 deg C at sea level, calibration can be reset by carefully holding the thermometer head and turning the hex nut with a wrench to move dial in one direction or the other.
- CAUTION - Do not adjust hot thermometer with bare hands!
- CAUTION - Do not hold thermometer with bare hands while placing in boiling water as burns can result!
- CAUTION - Thermometer tip is sharp, do not leave unattended or place within reach of children.
Product Reviews
There are no reviews yet for Big Green Egg: Temperature Gauge, 2 inch Dial .
Write a Review