Big Green Egg
Temperature Gauge, 2 inch Dial in Chillicothe, MO 64601
MSRP
Product Information
This high quality, stainless steel temperature gauge - with an easy-to-read dial - precisely monitors the temperatures inside the dome of an EGG, allowing you to achieve and maintain precise cooking temperatures 2 in Dial Stainless Steel External Temperature Gauge - 117236
- 750F deg / 400C deg
- Works with XXLarge, XLarge, Large, Medium, Small and MiniMax EGGs
- Heavy duty construction, hermetically sealed
- Designed and manufactured in the USA
Installation:
- Carefully insert stem from the outside through small hole in dome of the EGG; the silicone washer should remain on the outside of the EGG.
- Carefully reach inside the dome, and slide retaining clip onto the stem. Squeeze the clip so that it slides easily.
- Slide clip up the stem until the silicone washer -x001F-ts snugly against the exterior of the dome. For accurate reading, thermometer must be installed past the groove on the lower portion of stem as shown below.
This thermometer is calibrated and adjusted at the factory. If you are in high altitudes or wish to check the calibration:
- Bring a clean container of water to a boil.
- Carefully place the end of the thermometer probe into boiling water past the groove on the lower portion of stem. Leave immersed for at least one minute taking care not to let the probe rest on or make contact with the container.
- Boiling point will read 212 deg F/100 deg C at sea level. Boiling point decreases approx 2 deg with each 1000' of altitude. If the thermometer does not read 212 deg F/100 deg C at sea level, calibration can be reset by carefully holding the thermometer head and turning the hex nut with a wrench to move dial in one direction or the other.
- CAUTION - Do not adjust hot thermometer with bare hands!
- CAUTION - Do not hold thermometer with bare hands while placing in boiling water as burns can result!
- CAUTION - Thermometer tip is sharp, do not leave unattended or place within reach of children.
Select a Store
Selected Store
19 locations / In stock at 19
In stock at 18 other locations
Westlake Hardware 8
600 S Washington
Chillicothe, MO 64601
Westlake Hardware #1
1919 N Moberly Street
Moberly, MO 65270
Westlake Hardware #10
1205 N 7 Hwy
Blue Springs, MO 64015
Westlake Hardware #92
918 SW 7 Hwy
Blue Springs, MO 64015
Westlake Hardware 16
1325 S Belt Highway
St. Joseph, MO 64507
Westlake Hardware #78
5945 NE Antioch Rd
Gladstone, MO 64119
Westlake Ace Hardware #60
328 B East Young St
Warrensburg, MO 64093
Westlake Hardware #139
9200 NW Hwy 45
Parkville, MO 64152
Westlake Hardware 34
103 S 291 Highway
Lee's Summit, MO 64063
Westlake Hardware #59
1000 Westport Rd.
Kansas City, MO 64111
Westlake Ace Hardware 12
1010 Thompson Blvd
Sedalia, MO 65301
Westlake Ace Hardware 104
1409 S Main Street
Maryville, MO 64468
Westlake Hardware 44
4049 Somerset Drive
Prairie Village, KS 66208
Westlake Ace Hardware #17
12230 West 63rd St.
Shawnee, KS 66216
Porter's Building Center
700 E 92 Hwy
Kearney, MO 64060
Westlake Hardware 174
9715 N Ash Avenue
Kansas City, MO 64157
Miller Ace Hardware
1907 Boone Village Dr
Boonville, MO 65233
Westlake Hardware #183
3511 SW Market St
Lees Summit, MO 64082
Westlake Ace Hardware
6327 W 119th Street
Overland Park, KS 66209
Directions
Contact
Product Information
This high quality, stainless steel temperature gauge - with an easy-to-read dial - precisely monitors the temperatures inside the dome of an EGG, allowing you to achieve and maintain precise cooking temperatures 2 in Dial Stainless Steel External Temperature Gauge - 117236
- 750F deg / 400C deg
- Works with XXLarge, XLarge, Large, Medium, Small and MiniMax EGGs
- Heavy duty construction, hermetically sealed
- Designed and manufactured in the USA
Installation:
- Carefully insert stem from the outside through small hole in dome of the EGG; the silicone washer should remain on the outside of the EGG.
- Carefully reach inside the dome, and slide retaining clip onto the stem. Squeeze the clip so that it slides easily.
- Slide clip up the stem until the silicone washer -x001F-ts snugly against the exterior of the dome. For accurate reading, thermometer must be installed past the groove on the lower portion of stem as shown below.
This thermometer is calibrated and adjusted at the factory. If you are in high altitudes or wish to check the calibration:
- Bring a clean container of water to a boil.
- Carefully place the end of the thermometer probe into boiling water past the groove on the lower portion of stem. Leave immersed for at least one minute taking care not to let the probe rest on or make contact with the container.
- Boiling point will read 212 deg F/100 deg C at sea level. Boiling point decreases approx 2 deg with each 1000' of altitude. If the thermometer does not read 212 deg F/100 deg C at sea level, calibration can be reset by carefully holding the thermometer head and turning the hex nut with a wrench to move dial in one direction or the other.
- CAUTION - Do not adjust hot thermometer with bare hands!
- CAUTION - Do not hold thermometer with bare hands while placing in boiling water as burns can result!
- CAUTION - Thermometer tip is sharp, do not leave unattended or place within reach of children.
Product Reviews
There are no reviews yet for Big Green Egg: Temperature Gauge, 2 inch Dial .
Write a Review
